Aggiusta la tua roba

Diritto alla Riparazione

Store

Opening Procedure

In evidenza

Scritto Da: Tobias Isakeit (e un altro collaboratore)
  • Commenti: 2
  • Preferiti: 0
  • Completamenti: 3

Guida In Evidenza

Difficoltà

Facile

Passi

5

Tempo Necessario

5 minuti

Sezioni

1

Contrassegni

1

Featured Guide

Guida In Evidenza

Questa guida è stata giudicata eccezionalmente ben fatta dallo staff iFixit.

Introduzione

Use this guide to open the back cover of the Samsung Galaxy Watch.

  1. Remove the four Tri-point #00 screws (4.2 mm length) on the backside of the watch.

    • Remove the four Tri-point #00 screws (4.2 mm length) on the backside of the watch.

    Traduci

  2. Use an opening tool to get between the back cover and the metal housing of the watch. Carefully pry the plastic back cover open.

    • Use an opening tool to get between the back cover and the metal housing of the watch.

    • Carefully pry the plastic back cover open.

    • Don't remove the back cover yet. There is a flex cable running to the core assembly inside.

    Traduci

  3. SKIP THE UPGRADE

    Save by fixing with an all-in-one kit.

    Shop iPhone Fix Kits

    SKIP THE UPGRADE

    Save by fixing with an all-in-one kit.

    Shop iPhone Fix Kits

  4. Lay down the watch and lift the back cover to access the sensor connector on the motherboard. Lay down the watch and lift the back cover to access the sensor connector on the motherboard.

    • Lay down the watch and lift the back cover to access the sensor connector on the motherboard.

    Traduci

  5. Use a spudger to disconnect the sensor flex cable from the motherboard. Use a spudger to disconnect the sensor flex cable from the motherboard.

    • Use a spudger to disconnect the sensor flex cable from the motherboard.

    Traduci

  6. Remove the back cover. When closing the watch make sure the rubber gasket is undamaged or replace it with a new one. When closing the watch make sure the rubber gasket is undamaged or replace it with a new one.

    • Remove the back cover.

    • When closing the watch make sure the rubber gasket is undamaged or replace it with a new one.

    Traduci
Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 3 persone hanno completato questa guida.

Autore

con 1 altro collaboratore

Tobias Isakeit

Membro da: 31/03/2014

73.814 Reputazione

142 Guide realizzate

Distintivi: 45

+42 altri distintivi

Team

iFixit Membro di iFixit

Community

128 Membri

13.055 Guide realizzate

0 Commenti

Aggiungi un commento

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 8

Ultimi 7 Giorni: 34

Ultimi 30 Giorni: 163

Tutti i Tempi: 2,789