Introduzione

If the flash on your Olympus Stylus 410 no longer works, use this guide to replace it.

Parti

Nessuna parte richiesta.

Locate the 2 screws on the bottom of the slider.
  • Locate the 2 screws on the bottom of the slider.

  • Remove both screws with a #00 Phillips screwdriver.

Aggiungi Commento

Gently pull on the bottom of the slider until it comes off the lower track.
  • Gently pull on the bottom of the slider until it comes off the lower track.

  • There is a little piece that connects the slider to the track. Be sure not to lose this as it is needed to put the slider back on.

Aggiungi Commento

  • Lift the slider up until it comes off the upper track.

Aggiungi Commento

  • The slider should now be free from the body of the camera.

Aggiungi Commento

  • Locate the 3 screws on the outer metal band and remove them with a #00 Phillips screwdriver.

Aggiungi Commento

  • Use the spudger to peel off the outer metal band, starting from the bottom of the camera.

  • The metal band it attached to the camera with glue in addition to screws. Be careful not to bend the band when removing it from the camera.

Aggiungi Commento

  • The shutter button can now be removed. It is not connected to the camera and can be lifted off.

Aggiungi Commento

  • Remove the memory card.

  • Locate and remove the 2 screws using a #00 Phillips screwdriver.

Aggiungi Commento

  • Use a spudger around the edge of the case to loosen it.

  • Carefully wiggle the back case off. This may require a fair amount of force.

Aggiungi Commento

  • Locate the 3 internal screws holding on the front of the case. Remove them with a #00 Phillips screwdriver.

Aggiungi Commento

  • While grasping the interior and the front case, gently pull until they start to come apart. Some light wiggling may be required.

  • Be careful not to completely pull the front case off because it will still be connected with wires.

Aggiungi Commento

  • Locate the gray compartment covering the flash.

  • Position your flat head screw driver or small spudger underneath the tab that is keeping the gray cover on.

  • Gently lift the tab so the gray compartment becomes free.

Aggiungi Commento

  • Use the spudger around the perimeter of the gray compartment to detach it from the front case.

  • The gray compartment can now be removed from the flash unit.

  • The flash unit can now be removed, and a new one soldered back on.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Rory Aronson

Membro da: 15/04/2010

34 Reputazione

6 Guide realizzate

Team

Cal Poly, Team 6-13, Maness Spring 2010 Membro di Cal Poly, Team 6-13, Maness Spring 2010

CPSU-MANESS-S10S6G13

5 Membri

9 Guide realizzate

Good instructions, but author doesn't say where or how to get new flash unit!

Ken Arnoldi

ken arnoldi - Replica

Good instructions but author doesn't say how or where to get new flash unit!

ken arnoldi - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 4

Tutti i Tempi: 2,754