Salta al contenuto principale

Olympus D590 Retainer Clip Replacement

Cosa ti serve

  1. Olympus D590 Retainer Clip Replacement, Face Plate: passo 1, immagine 1 di 1
    • Remove five baseplate screws using a Phillips #00 screwdriver.

  2. Olympus D590 Retainer Clip Replacement: passo 2, immagine 1 di 1
    • Press and slide the battery cover retainer clip to the left. Use tweezers to lift the battery cover away.

  3. Olympus D590 Retainer Clip Replacement: passo 3, immagine 1 di 1
    • Remove the single screw from the battery housing using a Phillips #00 screwdriver.

  4. Olympus D590 Retainer Clip Replacement: passo 4, immagine 1 di 1
    • Using tweezers, lift the rubber plate to expose the ports.

  5. Olympus D590 Retainer Clip Replacement: passo 5, immagine 1 di 1
    • Remove two screws from the ports using a Phillips #00 screwdriver.

  6. Olympus D590 Retainer Clip Replacement: passo 6, immagine 1 di 1
    • Use a spudger to pry the faceplate away from the rest of the camera.

  7. Olympus D590 Retainer Clip Replacement: passo 7, immagine 1 di 1
    • To avoid disconnection of the connector line to the motherboard, use caution when pulling faceplate away from camera case.

    • Damage to the connector line will prevent the on/off power switch's operational function.

  8. Olympus D590 Retainer Clip Replacement, Retainer Clip: passo 8, immagine 1 di 1
    • Orient the camera as shown, with the bottom facing up.

    • Open the retainer clip, by using your finger to push down and slide to the left.

    • The clip should pop open.

  9. Olympus D590 Retainer Clip Replacement: passo 9, immagine 1 di 1
    • Hold the retainer clip down (without re-latching it).

    • Use a flathead screwdriver to start to pry out the pin holding the retainer clip's spring to the camera.

  10. Olympus D590 Retainer Clip Replacement: passo 10, immagine 1 di 1
    • Use tweezers to continue to remove the pin.

  11. Olympus D590 Retainer Clip Replacement: passo 11, immagine 1 di 1
    • When it feels loose, pull the pin all the way out with your fingers.

  12. Olympus D590 Retainer Clip Replacement: passo 12, immagine 1 di 1
    • Once the pin comes out, the retainer clip, spring, and pin will no longer be attached to the rest of the camera.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Katie

Membro da: 04/15/10

31 Reputazione

3 Guide realizzate

Team

Cal Poly, Team 28-23, Regan Spring 2010 Membro di Cal Poly, Team 28-23, Regan Spring 2010

CPSU-REGAN-S10S28G23

4 Membri

14 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 3

Tutti i Tempi: 2,140