Salta al contenuto principale

Olympus D590 Motherboard Replacement

Cosa ti serve

  1. Olympus D590 Motherboard Replacement, Face Plate: passo 1, immagine 1 di 1
    • Remove five baseplate screws using a Phillips #00 screwdriver.

  2. Olympus D590 Motherboard Replacement: passo 2, immagine 1 di 1
    • Press and slide the battery cover retainer clip to the left. Use tweezers to lift the battery cover away.

  3. Olympus D590 Motherboard Replacement: passo 3, immagine 1 di 1
    • Remove the single screw from the battery housing using a Phillips #00 screwdriver.

  4. Olympus D590 Motherboard Replacement: passo 4, immagine 1 di 1
    • Using tweezers, lift the rubber plate to expose the ports.

  5. Olympus D590 Motherboard Replacement: passo 5, immagine 1 di 1
    • Remove two screws from the ports using a Phillips #00 screwdriver.

  6. Olympus D590 Motherboard Replacement: passo 6, immagine 1 di 1
    • Use a spudger to pry the faceplate away from the rest of the camera.

  7. Olympus D590 Motherboard Replacement: passo 7, immagine 1 di 1
    • To avoid disconnection of the connector line to the motherboard, use caution when pulling faceplate away from camera case.

    • Damage to the connector line will prevent the on/off power switch's operational function.

  8. Olympus D590 Motherboard Replacement, Motherboard: passo 8, immagine 1 di 1
    • Remove four screws holding the motherboard to the internal housing component using a Phillips #1 screwdriver.

  9. Olympus D590 Motherboard Replacement: passo 9, immagine 1 di 1
    • Be cautious of the wires attached to the motherboard.

    • Remove the motherboard from the internal housing component.

    • Do not completely lift the motherboard out with the wiring connected. The wires must be disconnected before proceeding. The next step will demonstrate disconnection process.

  10. Olympus D590 Motherboard Replacement: passo 10, immagine 1 di 3 Olympus D590 Motherboard Replacement: passo 10, immagine 2 di 3 Olympus D590 Motherboard Replacement: passo 10, immagine 3 di 3
    • Use rounded tweezers to disconnect the three wiring strips from the motherboard.

    • Using sharp tweezers may tear wiring tape and wires.

    • Use gentle force when wiggling or pulling wiring tape and wires to disconnect from the motherboard.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 2 persone hanno completato questa guida.

Sara

Membro da: 04/15/10

84 Reputazione

2 Guide realizzate

Team

Cal Poly, Team 28-23, Regan Spring 2010 Membro di Cal Poly, Team 28-23, Regan Spring 2010

CPSU-REGAN-S10S28G23

4 Membri

14 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 1

Tutti i Tempi: 1,765