Salta al contenuto principale
  1. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    First, remove the stylus from your tablet. First, remove the stylus from your tablet.
    • First, remove the stylus from your tablet.

  2. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    Set the tablet so the buttons, microSD, and stylus port are facing you. Open the microSD slot. Using the flat end of the spudger tool, carefully pry open the case starting from the microSD slot, slowly sliding the spudger along the inside edge of the case.
    • Set the tablet so the buttons, microSD, and stylus port are facing you.

    • Open the microSD slot.

    • Using the flat end of the spudger tool, carefully pry open the case starting from the microSD slot, slowly sliding the spudger along the inside edge of the case.

    • You may want to put on your anti-static wrist strap at this point as the motherboard will be vulnerable to physical touch and electrostatic shock after the casing is removed.

  3. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    As you remove your case, be aware of small clips along the edges. Finally, set the old casing aside.
    • As you remove your case, be aware of small clips along the edges.

    • Finally, set the old casing aside.

  4. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    Orient your tablet so that the top of the tablet is furthest away from you.
    • Orient your tablet so that the top of the tablet is furthest away from you.

    • Locate the top speaker, a black semi-rectangular piece on the top right side of the tablet.

  5. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    Remove the two 3.0 mm Phillips #00 screws securing the speaker.
    • Remove the two 3.0 mm Phillips #00 screws securing the speaker.

  6. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    Gently pry the speaker up with the flat end of a spudger. Use a plastic opening tool to peel up the tape covering the speaker wire. Use a plastic opening tool to peel up the tape covering the speaker wire.
    • Gently pry the speaker up with the flat end of a spudger.

    • Use a plastic opening tool to peel up the tape covering the speaker wire.

  7. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    Next, with a gentle but firm grip, pull the audio input ribbon with the precision tweezers. Finally, unplug the power source from your speaker using the precision tweezers.
    • Next, with a gentle but firm grip, pull the audio input ribbon with the precision tweezers.

    • Finally, unplug the power source from your speaker using the precision tweezers.

    • Make sure you are using your anti-static wrist strap.

Linea Traguardo

Un'altra persona ha completato questa guida.

Molly Bauer

Membro da: 27/08/2015

1.396 Reputazione

6 Guide realizzate

Team

USF Tampa, Team 2-2, Blackwell Fall 2015 Membro di USF Tampa, Team 2-2, Blackwell Fall 2015

USFT-BLACKWELL-F15S2G2

3 Membri

11 Guide realizzate

Un commento

This didn't work

Riley Schork - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 7

Tutti i Tempi: 2,487