Aggiusta la tua roba Comunità Store

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

Numark N4 Effect button cover Replacement

Introduzione

This guide shows the reader how to replace the effect button cover. If this plastic part is damaged and doesn't touch the circuit board when pressure is applied, it is likely responsible for an unresponsive effects button.

Cosa ti serve

  1. Numark N4 Effect button cover Replacement, Numark N4 Disassembly: passo 1, immagine 1 di 1

    • Turn the Numark N4 over so that the bottom panel is facing upwards.

    • Loosen and remove the 17 12mm screws from the bottom panel using a Phillips #2 screwdriver.

    Traduci

  2. Numark N4 Effect button cover Replacement: passo 2, immagine 1 di 1

    • Using your fingers, gently pull apart the two panels of the device until you feel resistance from the cables.

    Traduci

  3. Numark N4 Effect button cover Replacement: passo 3, immagine 1 di 1

    • Using your fingers, gently unplug the larger ribbon cable as pictured.

    Traduci

  4. Numark N4 Effect button cover Replacement: passo 4, immagine 1 di 1

    • Using your fingers, gently unplug the smaller ribbon cable as pictured.

    Traduci

  6. Numark N4 Effect button cover Replacement: passo 5, immagine 1 di 1

    • Using your fingers, gently unplug the yellow and red cable as pictured.

    Traduci

  7. Numark N4 Effect button cover Replacement: passo 6, immagine 1 di 1

    • Open the two panels completely, gently placing each side on your working area to avoid damage to the buttons on the outside face.

    Traduci

  8. Numark N4 Effect button cover Replacement, Effect button cover: passo 7, immagine 1 di 1

    • Locate the top right PCB circuit board.

    Traduci

  9. Numark N4 Effect button cover Replacement: passo 8, immagine 1 di 1

    • Unplug the two ribbon cables as shown.

    Traduci

  10. Numark N4 Effect button cover Replacement: passo 9, immagine 1 di 1

    • Loosen and remove the 11 12mm screws from the circuit board using Phillips #2 screwdriver.

    Traduci

  11. Numark N4 Effect button cover Replacement: passo 10, immagine 1 di 1

    • Carefully remove the circuit board from its housing.

    Traduci

  12. Numark N4 Effect button cover Replacement: passo 11, immagine 1 di 1

    • Carefully remove the plastic button covers as depicted.

    Traduci
Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 2 persone hanno completato questa guida.

Autore

con 1 altro collaboratore

Erik Charlton

Membro da: 10/10/17

789 Reputazione

5 Guide realizzate

Distintivi: 14

+11 altri distintivi

Team

USF Tampa, Team S13-G11, Cagle Fall 2017 Membro di USF Tampa, Team S13-G11, Cagle Fall 2017

USFT-CAGLE-F17S13G11

4 Membri

12 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 4

Tutti i Tempi: 456