Salta al contenuto principale

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

Nokia 6085h Front LCD Display

Cosa ti serve

  1. Nokia 6085h Front LCD Display, Battery: passo 1, immagine 1 di 1
    • Flip over the phone so that the back is facing up.

    • Pressing your thumb against the back cover, slide the cover off of the phone.

  2. Nokia 6085h Front LCD Display: passo 2, immagine 1 di 1
    • Remove the phone's battery.

  3. Nokia 6085h Front LCD Display, Front LCD Display: passo 3, immagine 1 di 3 Nokia 6085h Front LCD Display, Front LCD Display: passo 3, immagine 2 di 3 Nokia 6085h Front LCD Display, Front LCD Display: passo 3, immagine 3 di 3
    • With the phone closed, run a plastic opening tool along the seam of the top half of the phone

    • Make sure to disconnect each of the five clips before proceeding (2 on each side, 1 on top)

  4. Nokia 6085h Front LCD Display: passo 4, immagine 1 di 2 Nokia 6085h Front LCD Display: passo 4, immagine 2 di 2
    • Using T6 Torx Screwdriver, remove the four 3.16mm screws from the front panel

    • Note that the fourth screw is under a fold in the ribbon cable

  5. Nokia 6085h Front LCD Display: passo 5, immagine 1 di 3 Nokia 6085h Front LCD Display: passo 5, immagine 2 di 3 Nokia 6085h Front LCD Display: passo 5, immagine 3 di 3
    • Starting in the lower right corner, slowly start to lift the tape that is holding the front LCD and cables down

    • Be careful around the two ribbon cables that are attached to the tape, they are fragile

    • Lift the tape from the board

  6. Nokia 6085h Front LCD Display: passo 6, immagine 1 di 1
    • Using a plastic opening tool, lift the ribbon cable connection below the front LCD

  7. Nokia 6085h Front LCD Display: passo 7, immagine 1 di 3 Nokia 6085h Front LCD Display: passo 7, immagine 2 di 3 Nokia 6085h Front LCD Display: passo 7, immagine 3 di 3
    • Using a plastic opening tool, slowly pry up the LCD display from the bottom, releasing it from the glue holding it to the board

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 2 persone hanno completato questa guida.

Team

Cal Poly, Team 4-46, Amido Fall 2010 Membro di Cal Poly, Team 4-46, Amido Fall 2010

CPSU-AMIDO-F10S4G46

4 Membri

14 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 3

Tutti i Tempi: 1,100