Introduzione

Replacing the charger connector.

Parti

Nessuna parte richiesta.

Press the grip on the back of the phone and slide the rear housing down towards the bottom of the phone.
  • Press the grip on the back of the phone and slide the rear housing down towards the bottom of the phone.

Aggiungi Commento

Use your fingernail and gently pull the the bottom of the battery up.
  • Use your fingernail and gently pull the the bottom of the battery up.

  • Lift out battery and remove.

Aggiungi Commento

  • Use your fingernail to lift the metal cage up.

  • Remove SIM card.

Aggiungi Commento

  • Close the metal cage.

Aggiungi Commento

  • Pull the top casing up after inserting thumbs under the two tabs labeled with the arrows. then slowly rotate up and over the screen.

Aggiungi Commento

  • After removing the top cover, turn the phone over so the screen is facing upwards.

Aggiungi Commento

  • Lift the front off the phone by pulling above the arrows.

Aggiungi Commento

  • Remove the six screws with a T-6 Torx screwdriver.

Aggiungi Commento

  • Lift the logic board and screen from the top.

  • Be careful of loose parts.

Aggiungi Commento

  • Insert the screwdriver below the charger connector and press down to pry out.

  • The charger connector should pop out with a slight push inwards with your thumb.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Team

Cal Poly, Team 23-63, Johann Spring 2010 Membro di Cal Poly, Team 23-63, Johann Spring 2010

CPSU-JOHANN-S10S23G63

3 Membri

17 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 12

Tutti i Tempi: 4,317