Parti

Nessuna parte richiesta.

  1. Slide the back cover down with your thumb.
    • Slide the back cover down with your thumb.

    • *Note: the battery cover is not shown in this picture

    Aggiungi Commento

  2. Gently lift the battery with a fingernail and remove it from its housing.
    • Gently lift the battery with a fingernail and remove it from its housing.

    • *Note: the battery may be replaced or repaired at this step

    Aggiungi Commento

    • On some models, the front case is screwed down from the back. Follow steps 5 and 6 FIRST to remove the camera cover and two T6 screws, before removing the faceplate.

    • Use the Spudger to gently pry up the edges of the front face plate

    • At the center of the faceplate edge below the music keys there is a small latch on each side.

    Before doing this step, first remove the camera cover and the two t6 screws from the back (steps 5 and 6). Otherwise you will break the cover. This may be a factor only for some revisions (RM-304)

    s c - Replica

  3. Spedizione gratuita per ordini superiori a $20
    Usa il codice BLUEANDBLACK al checkout
    Spedizione gratuita per ordini superiori a $20
    Usa il codice BLUEANDBLACK
    • Lift up the keypad from the bottom with either the spudger or your finger.

    • Note: at this time the keypad can be removed and replaced

    Aggiungi Commento

    • Gently unsnap the back camera cover from the phone.

    • Lift the cover from the phone after it is unsnapped.

    Aggiungi Commento

    • Use the T6 torx screwdriver head to remove the 2 screws on either side of the camera

    • Flip over the phone and again us the T6 torx head to remove the 4 screws located at each corner of the white keypad base

    Aggiungi Commento

    • Unclip the faceplate plug (ribbon) located in the lower left corner of the motherboard

    Aggiungi Commento

    • Use the Spudger to pry up the 2 metal clips located near the center of the motherboard on both the left and right

    • At this point the phone should come apart into 2 pieces, the motherboard/LCD screen and the faceplate

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 4 persone hanno completato questa guida.

Max Kirby

Membro da: 01/05/2011

515 Reputazione

4 Guide realizzate

Team

Cal Poly, Team 15-14, Regan Spring 2011 Membro di Cal Poly, Team 15-14, Regan Spring 2011

CPSU-REGAN-S11S15G14

3 Membri

8 Guide realizzate

Step 5 and 6 must be performed before step 3, otherwise, you will dislodge the thread from the front plate. so you have to remove the camera cover first, remove the 2 screws then you can remove the front plate without breaking anything.

Vincent Tschanz - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 10

Tutti i Tempi: 6,053