Aggiusta la tua roba Comunità Store

Nintendo Wii Remote Front Cover Plate and Batteries Replacement

Introduzione

Disassembling the case requires removing screws under the batteries. Removing anything inside requires this guide.

Cosa ti serve

  1. Nintendo Wii Remote Front Cover Plate and Batteries Replacement, Front Cover Plate and Batteries: passo 1, immagine 1 di 2 Nintendo Wii Remote Front Cover Plate and Batteries Replacement, Front Cover Plate and Batteries: passo 1, immagine 2 di 2

    • Flip the Wii Remote over so the battery cover faces you.

    • Push up on the bottom tab.

    • Remove the battery cover.

    Traduci

  2. Nintendo Wii Remote Front Cover Plate and Batteries Replacement: passo 2, immagine 1 di 1

    • Remove the first battery by pressing down on the positive end and pulling the battery out.

    • Remove the second battery by pushing up on the positive end and pulling the battery out.

    Traduci

  4. Nintendo Wii Remote Front Cover Plate and Batteries Replacement: passo 3, immagine 1 di 1

    • Using a tri-point Y1 Screwdriver, remove the two center 7mm screws by turning them counterclockwise.

    • Repeat with the two bottom screws.

    Traduci

  5. Nintendo Wii Remote Front Cover Plate and Batteries Replacement: passo 4, immagine 1 di 2 Nintendo Wii Remote Front Cover Plate and Batteries Replacement: passo 4, immagine 2 di 2

    • With the flat end of a spudger, gently apply pressure to the tabs located on left side of the controller.

    • These tabs are breakable. However, if the tabs are broken the controller will still function.

    • Open the front plate like a book.

    • Small parts may fall out as you open the front plate.

    Traduci
Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 36 persone hanno completato questa guida.

Autore

con 14 altri collaboratori

Emily

Membro da: 04/14/13

1.494 Reputazione

6 Guide realizzate

Distintivi: 13

+10 altri distintivi

Team

Cal Poly, Team 3-44, Amido Spring 2013 Membro di Cal Poly, Team 3-44, Amido Spring 2013

CPSU-AMIDO-S13S3G44

4 Membri

26 Guide realizzate

4 Commenti

Worked! Had to solder the tab to contact the battery which had broken. Saved $50.00.

Graham Poor - Replica

The Tools section lists a Tri-Point Y1 Screwdriver but the guide mentions a Tri-Wing Y1 Screwdriver. This could cause people to purchase the wrong item.

iFixit’s guides seem to be based on the original Wii controller, model RVL-003. I’m not sure if Nintendo has changed fasteners for subsequent versions but the Wii MotionPlus Controller, model RVL-036, uses a Tri-Wing Y0 screw.

kivrin - Replica

@kivrin Thanks for your comment. I’m pretty sure it should say tri-point, not tri-wing. I’ll update the instructions. Tri-wing screws have a more twisted/triangular form factor, like this.

Jeff Suovanen -

My controller (the original) had three tri-wing screws and one philips. Not sure why. Had to re-solder the negative battery terminal as it came off the bottom of the ‘top’ (faces bottom) of the board.

audvare - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 38

Ultimi 7 Giorni: 298

Ultimi 30 Giorni: 1,338

Tutti i Tempi: 103,162