Salta al contenuto principale

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

Nintendo DSi XL Rear Bezel Replacement

Solo Prerequisita
Questa guida รจ destinata a essere usata solo come prerequisito per altre guide. Da sola รจ incompleta.

Cosa ti serve

  1. Nintendo DSi XL Rear Bezel Replacement, Battery: passo 1, immagine 1 di 2 Nintendo DSi XL Rear Bezel Replacement, Battery: passo 1, immagine 2 di 2
    • Remove the two Phillips screws securing the battery cover to the back of the handheld console.

    • Lift the battery cover off the back of the DSi XL.

  2. Nintendo DSi XL Rear Bezel Replacement: passo 2, immagine 1 di 1
    • Lift the battery from the DSi XL.

  3. Nintendo DSi XL Rear Bezel Replacement, Lower Case: passo 3, immagine 1 di 3 Nintendo DSi XL Rear Bezel Replacement, Lower Case: passo 3, immagine 2 di 3 Nintendo DSi XL Rear Bezel Replacement, Lower Case: passo 3, immagine 3 di 3
    • Remove the four rubber screw covers on the lower case by prying them up with a push pin.

  4. Nintendo DSi XL Rear Bezel Replacement: passo 4, immagine 1 di 1
    • Remove the following seven Phillips screws that secure the lower case to the rest of the DSi XL:

    • Four silver 5.3 mm screws

    • Two black 5.3 mm screws

    • One black 2.5 mm screw

  5. Nintendo DSi XL Rear Bezel Replacement: passo 5, immagine 1 di 3 Nintendo DSi XL Rear Bezel Replacement: passo 5, immagine 2 di 3 Nintendo DSi XL Rear Bezel Replacement: passo 5, immagine 3 di 3
    • Turn the DSi XL over, and open the display.

    • Insert a spudger between the upper and lower case at the bottom left corner of the DSi.

    • Slide the spudger along the bottom edge of the upper case to release the latches securing the upper case to the lower case.

  6. Nintendo DSi XL Rear Bezel Replacement: passo 6, immagine 1 di 2 Nintendo DSi XL Rear Bezel Replacement: passo 6, immagine 2 di 2
    • Close the display and turn the DSi XL over.

    • Lift the lower case from the front edge.

    • Rotate the lower case away from the DSi.

    • The lower case cannot be completely removed yet, since it is still connected to the motherboard.

  7. Nintendo DSi XL Rear Bezel Replacement: passo 7, immagine 1 di 2 Nintendo DSi XL Rear Bezel Replacement: passo 7, immagine 2 di 2
    • Using a spudger, pry the SD card/right shoulder button connector off its socket.

    • Pry the volume button/left shoulder button connector off its socket on the motherboard with a spudger.

  8. Nintendo DSi XL Rear Bezel Replacement, Wi-Fi Board: passo 8, immagine 1 di 2 Nintendo DSi XL Rear Bezel Replacement, Wi-Fi Board: passo 8, immagine 2 di 2
    • Lift the Wi-Fi board up off its socket on the motherboard.

    • Do not attempt to completely remove the Wi-Fi board yet. It is attached to the motherboard by an antenna cable.

  9. Nintendo DSi XL Rear Bezel Replacement: passo 9, immagine 1 di 1
    • Use a spudger to pry the Wi-Fi cable off its socket on the underside of the Wi-Fi board.

  10. Nintendo DSi XL Rear Bezel Replacement, Motherboard: passo 10, immagine 1 di 1
    • Use a spudger to pry the microphone cable off the motherboard.

    • Pry from underneath the cable.

  11. Nintendo DSi XL Rear Bezel Replacement: passo 11, immagine 1 di 2 Nintendo DSi XL Rear Bezel Replacement: passo 11, immagine 2 di 2
    • Using the flat end of a spudger, flip up the retaining flap on the camera ribbon ZIF connector.

    • Use the pointed end of a spudger to pull the camera ribbon from the ZIF connector.

  12. Nintendo DSi XL Rear Bezel Replacement: passo 12, immagine 1 di 2 Nintendo DSi XL Rear Bezel Replacement: passo 12, immagine 2 di 2
    • Using the flat end of a spudger, flip up the retaining flap on the touchscreen cable ZIF connector.

    • With the pointed end of the spudger, pull the touchscreen cable from its connector on the motherboard.

  13. Nintendo DSi XL Rear Bezel Replacement: passo 13, immagine 1 di 2 Nintendo DSi XL Rear Bezel Replacement: passo 13, immagine 2 di 2
    • Using the flat end of a spudger, flip up the retaining flap on the backlight cable ZIF connector.

    • With the pointed end of the spudger, pull the backlight cable from its connector on the motherboard.

  14. Nintendo DSi XL Rear Bezel Replacement: passo 14, immagine 1 di 2 Nintendo DSi XL Rear Bezel Replacement: passo 14, immagine 2 di 2
    • Using the flat end of a spudger, flip up the retaining flap on the lower display data cable ZIF connector.

    • With the pointed end of the spudger, pull the lower display data cable from its connector on the motherboard.

  15. Nintendo DSi XL Rear Bezel Replacement: passo 15, immagine 1 di 2 Nintendo DSi XL Rear Bezel Replacement: passo 15, immagine 2 di 2
    • Using the flat end of a spudger, flip up the retaining flap on the ZIF connector for the D-Pad/power button cable.

    • With the pointed end of the spudger, pull the D-Pad/power button cable from its connector on the motherboard.

  16. Nintendo DSi XL Rear Bezel Replacement: passo 16, immagine 1 di 1
    • Using the flat end of the spudger, pry the battery cable up off its socket on the motherboard.

  17. Nintendo DSi XL Rear Bezel Replacement: passo 17, immagine 1 di 1
    • Remove the screws securing the motherboard to the upper case:

    • A single 2.5 mm silver Phillips screw

    • Four 3.7 mm black Phillips screws

  18. Nintendo DSi XL Rear Bezel Replacement: passo 18, immagine 1 di 1
    • Deroute the microphone and antenna cables through the slot in the motherboard.

  19. Nintendo DSi XL Rear Bezel Replacement: passo 19, immagine 1 di 2 Nintendo DSi XL Rear Bezel Replacement: passo 19, immagine 2 di 2
    • Rotate the motherboard off the lower case.

    • The motherboard cannot be completely removed yet. It is still attached by the upper LCD's display data ribbon cable.

  20. Nintendo DSi XL Rear Bezel Replacement: passo 20, immagine 1 di 2 Nintendo DSi XL Rear Bezel Replacement: passo 20, immagine 2 di 2
    • Using the flat end of a spudger, flip up the retaining flap on the upper display data cable ZIF connector.

    • With the pointed end of the spudger, pull the upper display data cable from its connector on the underside of the motherboard.

    • The motherboard is now free from the upper case.

  21. Nintendo DSi XL Rear Bezel Replacement, Lower Display Assembly: passo 21, immagine 1 di 2 Nintendo DSi XL Rear Bezel Replacement, Lower Display Assembly: passo 21, immagine 2 di 2
    • With the console still upside-down, open the DSi XL slightly.

    • Push the lower display away from the upper case.

    • Remove the lower display from the DSi XL.

  22. Nintendo DSi XL Rear Bezel Replacement, Rear Bezel: passo 22, immagine 1 di 3 Nintendo DSi XL Rear Bezel Replacement, Rear Bezel: passo 22, immagine 2 di 3 Nintendo DSi XL Rear Bezel Replacement, Rear Bezel: passo 22, immagine 3 di 3
    • Turn the DSi XL over and open the display.

    • When re-assembling the device, be sure to re-install the ABXY and Start/Select buttons, as they are likely to fall out once the handheld console is turned over.

    • Use a pushpin to remove the four plastic screw covers on the front bezel.

  23. Nintendo DSi XL Rear Bezel Replacement: passo 23, immagine 1 di 1
    • Remove the four 3.5 mm silver Phillips screws securing the rear bezel to the front bezel.

  24. Nintendo DSi XL Rear Bezel Replacement: passo 24, immagine 1 di 2 Nintendo DSi XL Rear Bezel Replacement: passo 24, immagine 2 di 2
    • Using two hands, gently slide the rear bezel upwards.

    • The rear bezel will move only about 2 mm.

  25. Nintendo DSi XL Rear Bezel Replacement: passo 25, immagine 1 di 2 Nintendo DSi XL Rear Bezel Replacement: passo 25, immagine 2 di 2
    • Insert a spudger into the gap between the front and rear bezel.

    • Rotate the spudger away from the DSi XL, prying the two bezels apart.

  26. Nintendo DSi XL Rear Bezel Replacement: passo 26, immagine 1 di 2 Nintendo DSi XL Rear Bezel Replacement: passo 26, immagine 2 di 2
    • In the same manner as described above, continue prying along the top edge of the front and rear bezels.

  27. Nintendo DSi XL Rear Bezel Replacement: passo 27, immagine 1 di 1
    • Separate the rear bezel from the front bezel.

    • Do not attempt to completely remove the rear bezel yet. It is still attached to the front bezel by the rear-facing camera.

  28. Nintendo DSi XL Rear Bezel Replacement: passo 28, immagine 1 di 1
    • Using the flat end of a spudger, pry the rear camera off the rear bezel.

    • Remove the rear bezel.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Brett Hartt

Membro da: 04/12/10

127.749 Reputazione

143 Guide realizzate

Team

iFixit Membro di iFixit

Staff

136 Membri

16.573 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 591