Salta al contenuto principale

Nintendo 3DS Lower Case Replacement

Cosa ti serve

  1. Nintendo 3DS Lower Case Replacement, Back Cover: passo 1, immagine 1 di 1
    • Unscrew the four Phillips #00 screws along the top of the back cover.

    • The screws are held in place by locking washers, and will not come out of the back cover.

    • The comments section is full of unlucky souls who will tell you that the screws here through step 4 will strip incredibly easily. Press down fairly hard, and go slow.

  2. Nintendo 3DS Lower Case Replacement: passo 2, immagine 1 di 2 Nintendo 3DS Lower Case Replacement: passo 2, immagine 2 di 2
    • Hold the device in one hand and turn it over.

    • Grab the top edge of the back cover with your opposite hand so that the cover does not fall back into place.

    • Flip the 3DS over again so that the back cover is facing up.

    • Pull the back cover up and away from the rest of the device to remove it.

  3. Nintendo 3DS Lower Case Replacement, Battery: passo 3, immagine 1 di 3 Nintendo 3DS Lower Case Replacement, Battery: passo 3, immagine 2 di 3 Nintendo 3DS Lower Case Replacement, Battery: passo 3, immagine 3 di 3
    • Insert a plastic opening tool into the notch in the lower case above the battery.

    • Pry the battery up with the plastic opening tool.

    • Grab the top edge of the battery and lift it out of the lower case.

  4. Nintendo 3DS Lower Case Replacement, Lower Case: passo 4, immagine 1 di 1
    • Remove the nine 6.3 mm black Phillips screws from the lower case.

    • These screws will strip very easily unless you use the correct size bit. Apply pressure to the screws while turning to avoid stripping them.

    • Remove the 2.4 mm silver Phillips screw above the game cartridge slot.

  5. Nintendo 3DS Lower Case Replacement: passo 5, immagine 1 di 3 Nintendo 3DS Lower Case Replacement: passo 5, immagine 2 di 3 Nintendo 3DS Lower Case Replacement: passo 5, immagine 3 di 3
    • Lift the bottom edge of the lower case off the rest of the 3DS.

    • There are still two ribbon cables connecting the mother board to the case, so be sure not to pull the lower case all the way off.

    • Use a plastic opening tool to pry the shoulder button ribbon cables off their sockets on the motherboard.

    • Remove the lower case from the device.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 7 persone hanno completato questa guida.

David Hodson

Membro da: 04/13/10

150.352 Reputazione

127 Guide realizzate

2 Commenti

Is this guide for the original 3ds?

Glenn Racz - Replica

yessir it is

Electronik -

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 15

Ultimi 30 Giorni: 99

Tutti i Tempi: 15,585