Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Slide the eyepiece up and off the viewfinder.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using a PH000 screwdriver, remove the two 4.8mm Phillips screws from the back of the viewfinder.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the two 6.4mm Phillips screws on the right side of the camera, near the SD card slot.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the two 6.4mm Phillips screws on the left side of the camera, near the I/O ports.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
On the bottom of the camera,
-
remove the two 5.3mm Phillips screws
-
and the other two 6.3mm Phillips screws.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using a spudger, separate the bottom panel from the rear case just enough to clear the two clips on the rear casing in the next step.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Lift the rear case off of the back of the camera.
-
Be mindful of the two clips, making sure to keep the bottom panel far enough away to clear them.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Set the rear casing off to the side so you can access the ZIF connectors.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a spudger to lift the black tab on the ZIF connector.
-
Disconnect the ribbon cables from their respective ZIF connectors on the logic board.
-
Annulla: non ho completato questa guida.
Altre 8 persone hanno completato questa guida.
2 Commenti
good guidance,easy to follow,thanks
I want to replace my Nikon D90 DSLR bad LCD, this guide will save me from costly repairs.