Salta al contenuto principale

Introduzione

The spring of the camera flash can sometimes wear out and needs to be replaced. This guide shows how to replace the spring within the hinge of the camera flash. Be careful not to strip any screws when disassembling the camera.

  1. Use a plastic opening tool to lift up the flash. Use a plastic opening tool to lift up the flash. Use a plastic opening tool to lift up the flash.
    • Use a plastic opening tool to lift up the flash.

  2. Using a PH00 screwdriver, remove the two 5.3 mm Phillips screws from the flash casing. Be careful not to strip the screw heads.
    • Using a PH00 screwdriver, remove the two 5.3 mm Phillips screws from the flash casing.

    • Be careful not to strip the screw heads.

  3. Use a plastic opening tool and carefully pry open the top casing of the flash. Then, lift off the top casing of the flash. Then, lift off the top casing of the flash.
    • Use a plastic opening tool and carefully pry open the top casing of the flash.

    • Then, lift off the top casing of the flash.

  4. Using a PH00 screwdriver, loosen the 3.3 mm Phillips screw from the spring. Using a PH00 screwdriver, loosen the 3.3 mm Phillips screw from the spring.
    • Using a PH00 screwdriver, loosen the 3.3 mm Phillips screw from the spring.

  5. Use a plastic opening tool and carefully pry up the spring arm. Doing this with release the pressure of the spring.
    • Use a plastic opening tool and carefully pry up the spring arm.

    • Doing this with release the pressure of the spring.

  6. Finish removing the screw holding the spring in place. The spring can now be removed and replaced.
    • Finish removing the screw holding the spring in place.

    • The spring can now be removed and replaced.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Matthew Grota

Membro da: 16/10/2014

586 Reputazione

3 Guide realizzate

Team

UMass Dartmouth, Team 1-7, Duarte Fall 2014 Membro di UMass Dartmouth, Team 1-7, Duarte Fall 2014

UMASSD-DUARTE-F14S1G7

3 Membri

6 Guide realizzate

Un commento

These are great tutorials,

I was looking for one on how to fix the pop up flash not locking down,

It was bought second hand and dropped on the logo,

The front panel needed to be replaced,

Now for the Flash that is constantly up.

Any links? jjryzler@gmail.com

Ryad Arlan - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 19

Tutti i Tempi: 3,607