Parti

Nessuna parte richiesta.

  1. Remove the five screws on the bottom of the camera with a JIS #000 head screwdriver.
    • Remove the five screws on the bottom of the camera with a JIS #000 head screwdriver.

    Aggiungi Commento

  2. Remove the 3 screws under the battery flap and remove the bottom cover.
    • Remove the 3 screws under the battery flap and remove the bottom cover.

    Aggiungi Commento

    • Remove the 2 screws inside the camera on the back corners.

    Aggiungi Commento

    • Open the HDMI flap and remove the 2 screws.

    Aggiungi Commento

    • Remove the screw next to the camera strap loop.

    Aggiungi Commento

    • Remove the 2 screws on each side of the view finder.

    Aggiungi Commento

    • Remove the 2 screws above and below the SD card flap.

    Aggiungi Commento

    • Peel off the adhesive leather screw cover and remove the 2 screws under it.

    Aggiungi Commento

    • Remove the Diopter adjustment control sticker and remove the screw under it.

    Aggiungi Commento

    • Separate the back panel of the camera from the actual camera.

    • Be careful not to tear any of the ribbon cables.

    Aggiungi Commento

    • Disconnect the LCD ribbon cables and power cable from the motherboard.

    Aggiungi Commento

    • Unscrew all 16 screws around the back plate of the camera.

    Aggiungi Commento

    • Then unscrew the remaining screws holding the back plate to the LCD.

    • Then simply remove the plate with the LCD.

    Aggiungi Commento

    • Undo the 5 ribbon cable connectors by flipping the latches up with a plastic spudger.

    Aggiungi Commento

    • Remove the black 4 pin connector by pulling it out of the connector.

    Aggiungi Commento

    • Remove the 7 screws holding the motherboard in place.

    Aggiungi Commento

    • This is what you should see after removing the motherboard.

    Aggiungi Commento

    • After following the guide to remove the back LCD screen from the motherboard, remove the 2 marked screws.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Wesley Eveld

Membro da: 20/02/2018

588 Reputazione

4 Guide realizzate

Team

USF Tampa, Team S11-G6, Cheng Spring 2018 Membro di USF Tampa, Team S11-G6, Cheng Spring 2018

USFT-CHENG-S18S11G6

4 Membri

5 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 9

Ultimi 30 Giorni: 20

Tutti i Tempi: 127