Salta al contenuto principale

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

Nikon D5100 LCD Replacement

Cosa ti serve

  1. Nikon D5100 LCD Replacement, LCD: passo 1, immagine 1 di 2 Nikon D5100 LCD Replacement, LCD: passo 1, immagine 2 di 2
    • Using a screwdriver, remove the four screws around the perimeter of the LCD panel.

  2. Nikon D5100 LCD Replacement: passo 2, immagine 1 di 1
    • Using a fingernail or the flat edge of a spudger inserted into the seam, separate the LCD bevel from the main panel body.

  3. Nikon D5100 LCD Replacement: passo 3, immagine 1 di 2 Nikon D5100 LCD Replacement: passo 3, immagine 2 di 2
    • Remove the ribbon cables on the LCD's circuitboard by flipping up their plastic clasps and removing it from their casing.

  4. Nikon D5100 LCD Replacement: passo 4, immagine 1 di 1
    • Disconnect the 16-pin cable by gently pulling it upward, away from the circuitboard, until it is removed from its port.

  5. Nikon D5100 LCD Replacement: passo 5, immagine 1 di 1
    • Desolder the 3 wires (red, yellow, and black) connecting the LCD board to the main camera body.

  6. Nikon D5100 LCD Replacement: passo 6, immagine 1 di 2 Nikon D5100 LCD Replacement: passo 6, immagine 2 di 2
    • The LCD assembly can now be fully separated from the main camera body.

    • Remove the plastic bezel and metal bracket from the LCD itself to complete the removal process.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 9 persone hanno completato questa guida.

Liz

Membro da: 04/25/14

1.311 Reputazione

5 Guide realizzate

Team

Cal Poly, Team 10-54, Amido Spring 2014 Membro di Cal Poly, Team 10-54, Amido Spring 2014

CPSU-AMIDO-S14S10G54

4 Membri

5 Guide realizzate

6 Commenti

Thank you so much! My camera was dropped . And yelow and black wires came off. Now i will try to fix it.

What is the functions of these wires?

Ilia - Replica

Thanks for this Liz.

Removing the broken LCD from my Nikon D5100 seems like something I can do now!

I am unsure ?how to do the soldering bit to attach the new LCD, ?where to attach the wires...

Any help is welcome

Felipe Castro - Replica

I was able to fix it, thanks to you guys. But the colors that came on the, LCD are weird. At least I can see the image.

Arline Osuna - Replica

It’s very possible that applying the soldering iron to the board, while still attached to the back, caused the LCD to lose its color alignment and darken the display. I made the same mistake.

Franky -

I am having trouble reconnecting the 16-pin cable to the circuit board. Do you have any tips?

Lyle Ralston - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 17

Ultimi 30 Giorni: 71

Tutti i Tempi: 11,732