Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove two of the 4mm screws indicated by the circles on the bottom side of the camera.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove four of the 3mm screws around the eye piece located on the top of the back panel, including the screw hidden behind the auto focus label.
-
Remove the 3mm screw behind the rubber grip on the top right of the back panel.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Peel back the rubber grip on the right side of the camera using a spudger.
-
Remove two of the 5mm screws under the rubber grip.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove two of the 4mm screws on the left side of the camera.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Starting from the top, gently lift the back panel of the camera off. Slowly separate the back panel from the main body of the camera.
-
Carefully remove the ribbon using a spudger to lift up the connector and then use tweezers to pull out the ribbon.
-
Separate the back panel from the main body of the camera.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove nine of the 3mm screws connecting the metal plate to the plastic panel.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the two ribbons connecting the LCD screen to the metal plate using the same method from Step 5.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the old LCD screen from metal plate.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use tweezers to gently lift the yellow tape from the back of the camera.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a plastic spudger to remove the 6 ribbons.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the plug located on the top-right side of the camera.
-
Remove the plug located on the top-left side of the camera.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a Philips #00 Screwdriver to remove the five 3 mm screws marked in the image.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Gently pull out the side wall of the camera so that the motherboard comes out easier.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Gently lift the motherboard to separate it from the back of the camera.
-
Use a plastic spudger to detach the ribbon.
-
Annulla: non ho completato questa guida.
Altre 4 persone hanno completato questa guida.