Salta al contenuto principale

Introduzione

You will need a #00 phillip's head screwdriver and a black spudger (or equivalent tool).

Ricambi

Nessuna parte specificata.

  1. Turn the camera over to find 5 screws.
    • Turn the camera over to find 5 screws.

  2. Remove all 5 screws from the bottom of the camera and store them carefully.
    • Remove all 5 screws from the bottom of the camera and store them carefully.

  3. Open the battery door by sliding it in the direction of the arrow to reveal a hidden screw on the opposite side of orange lever.
    • Open the battery door by sliding it in the direction of the arrow to reveal a hidden screw on the opposite side of orange lever.

    • Remove this screw.

  4. Rotate the camera to find the side panel with lanyard attachment. Detach the side panel by the lifting bottom corner slightly with the spudger.
    • Rotate the camera to find the side panel with lanyard attachment. Detach the side panel by the lifting bottom corner slightly with the spudger.

  5. Lift the back cover, being careful not to rip the orange cables between the camera and the back cover.
    • Lift the back cover, being careful not to rip the orange cables between the camera and the back cover.

  6. With the back cover lifted, lift the black flap that connects the ribbon to the motherboard with the spudger and carefully remove the back cover.
    • With the back cover lifted, lift the black flap that connects the ribbon to the motherboard with the spudger and carefully remove the back cover.

  7. Remove the five screws on the metal plate. One of them is in a hole in the corner of the metal plate. Remove the screw at the bottom of the camera.
    • Remove the five screws on the metal plate.

    • One of them is in a hole in the corner of the metal plate.

    • Remove the screw at the bottom of the camera.

    • Carefully lift the metal plate from the right side to reveal a ribbon connected to the motherboard.

  8. Lift the white flap with the spudger to release the ribbon. Remove the back metal plate.
    • Lift the white flap with the spudger to release the ribbon.

    • Remove the back metal plate.

  9. Lift the two ribbons with the spudger to disconnect the lens and pull it out. Lift the two ribbons with the spudger to disconnect the lens and pull it out. Lift the two ribbons with the spudger to disconnect the lens and pull it out.
    • Lift the two ribbons with the spudger to disconnect the lens and pull it out.

  10. Lift two flaps with the spudger on the top of the motherboard to release ribbons. Lift two flaps with the spudger on the top of the motherboard to release ribbons.
    • Lift two flaps with the spudger on the top of the motherboard to release ribbons.

  11. lift motherboard from the top to remove it from the camera. lift motherboard from the top to remove it from the camera.
    • lift motherboard from the top to remove it from the camera.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Ryan

Membro da: 12/04/2011

146 Reputazione

6 Guide realizzate

Team

Cal Poly, Team 18-24, Garner Spring 2011 Membro di Cal Poly, Team 18-24, Garner Spring 2011

CPSU-GARNER-S11S18G24

4 Membri

6 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 2

Tutti i Tempi: 1,665