Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove two 5 mm Phillips #000 screws on the right hand side of the camera located near the power button.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove two 5 mm Phillips #000 screws near the audio/video inputs on the opposite side near the flash component.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove three 5 mm Phillips #000 screws on the bottom end of the camera.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Carefully detach the back side of the camera by lifting both ends, with moderate force wobble until loosened enough to remove.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
With the LCD screen facing towards you, flip the screen to the right.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove three 5 mm Phillips #000 screws located on the bracket.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Disconnect the ribbons that connect the LCD screen to the camera gently using precision tweezers or fingers.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove three 5 mm Phillips #000 screws bordering the motherboard.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the plastic component located directly behind the flash from its rubberized holder.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the electric tape covering the wires.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Unsolder all the wires that are on the top of the motherboard near the flash component.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Unsolder the wires on the bottom end of the motherboard.
-
Annulla: non ho completato questa guida.
Altre 2 persone hanno completato questa guida.
4 Commenti
The guide is incomplete! Do not try to remove the mobo for it is soldered to some other tiny board under the on/off switch. Trying to remove the mobo after just unscrewing it, may guide to certain and permanent destruction of both PCBs!!!
This guide should be for beginners, Mr. Symeon Leriou, and you will not only write "Mobo", but also motherboard or Mainboard or Hauptplatine (deutsch)
But I agree with you that it is not complete.
The motherboard is soldered to the on / off board (power supply for the batteries).
Soldering again is almost impossible ...