Aggiusta la tua roba Comunità Store

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

Nikon COOLPIX S610c LCD Replacement

Introduzione

If your screen has stopped working or needs to be replaced for some other reason, follow this guide to remove your current screen.

Cosa ti serve

  1. Nikon COOLPIX S610c LCD Replacement, Battery: passo 1, immagine 1 di 1

    • On the bottom right of the camera, locate the battery flap switch.

    Traduci

  2. Nikon COOLPIX S610c LCD Replacement: passo 2, immagine 1 di 1

    • Move this switch to the right so the battery flap can flip open.

    Traduci

  3. Nikon COOLPIX S610c LCD Replacement: passo 3, immagine 1 di 1

    • Slide the orange switch to the right as shown. Now the battery can be pulled out. Reverse these steps to re-install.

    Traduci

  4. Nikon COOLPIX S610c LCD Replacement, Rear Casing: passo 4, immagine 1 di 1

    • Remove the three 3x3mm screws attached to the rear casing.

    Traduci

  6. Nikon COOLPIX S610c LCD Replacement: passo 5, immagine 1 di 1

    • The panel can be identified by the wifi logo on its upper half on the camera's side.

    • Remove the 5x3mm screw holding down the panel on the side closest to the lens.

    Traduci

  7. Nikon COOLPIX S610c LCD Replacement: passo 6, immagine 1 di 1

    • Pry the panel off from the bottom using your fingernail.

    Traduci

  8. Nikon COOLPIX S610c LCD Replacement: passo 7, immagine 1 di 1

    • Remove the 3x2mm screw underneath the panel near the top of the camera.

    Traduci

  9. Nikon COOLPIX S610c LCD Replacement: passo 8, immagine 1 di 2 Nikon COOLPIX S610c LCD Replacement: passo 8, immagine 2 di 2

    • Remove the 4x3mm on the opposite side near the selector wheel.

    • Remove the 2x2mm and 3x2mm screws underneath the a/v flap.

    Traduci

  10. Nikon COOLPIX S610c LCD Replacement: passo 9, immagine 1 di 2 Nikon COOLPIX S610c LCD Replacement: passo 9, immagine 2 di 2

    • Pry the back panel away from the body of the camera, using the space you just opened up.

    • Be careful not to damage the ribbon cable on the opposite end of the camera.

    • A small piece of the frame of the camera may fall off, but it can be easily put back into place during reassembly.

    Traduci

  11. Nikon COOLPIX S610c LCD Replacement: passo 10, immagine 1 di 2 Nikon COOLPIX S610c LCD Replacement: passo 10, immagine 2 di 2

    • Pry up the plastic ribbon connectors on the body of the camera to release the ribbon cables.

    • The center connector is detached by flipping the black latch up and away from the center of the camera.

    • The smaller connector is detached by flipping the tan latch up and away from the edge of the camera.

    Traduci

  12. Nikon COOLPIX S610c LCD Replacement, LCD: passo 11, immagine 1 di 2 Nikon COOLPIX S610c LCD Replacement, LCD: passo 11, immagine 2 di 2

    • Pry the display from the rear casing using a spudger.

    Traduci
Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

con 3 altri collaboratori

Kevin Backers

Membro da: 01/26/12

301 Reputazione

4 Guide realizzate

Distintivi: 6

+3 altri distintivi

Team

Cal Poly, Team 9-5, Regan Winter 2012 Membro di Cal Poly, Team 9-5, Regan Winter 2012

CPSU-REGAN-W12S9G5

5 Membri

12 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 12

Tutti i Tempi: 549