Salta al contenuto principale

Introduzione

This is a relatively easy repair to make to your Q. Follow the prerequisite for removing the inner dome daughterboard to get started.

  1. Squeeze and pull to pop the cap off of the Nexus Q.
    • Squeeze and pull to pop the cap off of the Nexus Q.

  2. Disconnect the taoglas Wi-Fi Dual Band Antenna by prying with a spudger. Once the antenna is disconnected, simply pull it off the outside of the inner dome.
    • Disconnect the taoglas Wi-Fi Dual Band Antenna by prying with a spudger.

    • Once the antenna is disconnected, simply pull it off the outside of the inner dome.

  3. Undo the ZIF connector by prying with a spudger.
    • Undo the ZIF connector by prying with a spudger.

  4. Use a T10 Torx screwdriver to remove the four 1.3 mm screws holding the inner dome in place.
    • Use a T10 Torx screwdriver to remove the four 1.3 mm screws holding the inner dome in place.

  5. Use a T6 Torx screwdriver to undo the three 0.8 mm screws holding the inner dome daughterboard in place.
    • Use a T6 Torx screwdriver to undo the three 0.8 mm screws holding the inner dome daughterboard in place.

  6. Use a spudger to disconnect the daughterboard from the ZIF connector.
    • Use a spudger to disconnect the daughterboard from the ZIF connector.

  7. Use a spudger to pry out the NFC antenna. The antenna has two layers; be careful not to pry the two layers apart.
    • Use a spudger to pry out the NFC antenna.

    • The antenna has two layers; be careful not to pry the two layers apart.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Alex Thomas

Membro da: 31/01/2013

27 Reputazione

3 Guide realizzate

Team

Cal Poly, Team 7-10, Maness Winter 2013 Membro di Cal Poly, Team 7-10, Maness Winter 2013

CPSU-MANESS-W13S7G10

4 Membri

5 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 1

Tutti i Tempi: 530