Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
-
Prima di iniziare lo smontaggio, rimuovi:
-
La penna
-
La cartuccia di gioco
-
La scheda SD
-
-
-
Svita le quattro viti tri-point da 6 mm posizionate nei quattro angoli del pannello inferiore.
-
-
-
Usando uno spudger, separa il pannello posteriore dalla copertura anteriore facendo leva delicatamente attorno al pannello.
-
Ci sono diversi ganci lungo la cerniera della copertura, quindi ti consigliamo di lavorare su un lato corto e i due lati lunghi prima di finire con l'ultimo lato corto.
-
-
-
-
Usando uno spudger, solleva la batteria.
-
Ricordati che c'è un pad adesivo che tiene la batteria ferma sul suo supporto. Potrebbe essere necessario usare diversi strumenti per separare la batteria dal suo supporto e dalla scheda madre.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
There are 8 ribbon cables that need to be removed as shown in the picture.
-
For the remaining 6 (in red), use a pair of tweezers to flip the latches up and pull the ribbon cable out.
-
Note that the second picture shows a broken ribbon connector next to the joystick ribbon connector (to the right of the red arrow). Do not attempt to unlatch this connector as shown in the picture!
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Unplug the following wires from the motherboard using a pair of tweezers.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the seven 4.4 mm screws using a J00 Phillips screwdriver bit.
-
Remove the motherboard from the device.
-
Annulla: non ho completato questa guida.
Altre 9 persone hanno completato questa guida.
4 Commenti
On step 6, what is the top left circled connector for?
The screen on the device I am repairing keeping going black and this connector is damaged. (it doesn’t clamp shut)
Can anyone recommend where to buy a replacement board connector?
This doesn’t actually give ALL the tools you need. You can’t use a Tri point screwdriver on the CROSS screws that are in the pictures on the motherboard.
I know this might be a year too late, but the tri point is required for removing the back plate of the system. If you don't have a small philips head laying around your house, idk what to tell ya
Followed on a 2ds having bad input feedback, no major issue. screws on motherboard are cross so you need a small one (most diy nintendo kits have one) and a small clamp (like the one in pictures) is mandatory for the 7 small cables. there is something a bit tricky regarding volume button which is a bit hard to get back in place when you reassemble the console, take care of pushing the inner slider to the most far position for easier mounting.