Introduzione

A quick and simple guide for replacing the infrared LED board in the Netgear Arlo security camera.

  1. Remove the 2 (3.5mm) housing screws with a J0 screwdriver.
    • Remove the 2 (3.5mm) housing screws with a J0 screwdriver.

    Aggiungi Commento

  2. Slide the unlocked battery cover forward to remove 2 (3.5mm) screws, that are behind the cover.
    • Slide the unlocked battery cover forward to remove 2 (3.5mm) screws, that are behind the cover.

    Aggiungi Commento

    • Open the battery cover and remove the 2 (3.5mm") screws from under the cover.

    Aggiungi Commento

    • Use a plastic opening tool to start separating the plastic housing from the front side of the battery cover.

    • Next, start separating the plastic cover from the rear of the plastic housing, and work your way down the seam line.

    • Make sure the plastics snaps on the front of the plastic get unhooked from the grey plastic ring around the front of the camera.

    Aggiungi Commento

    • Remove the screw (3.5mm) near the sync button holding the opposite side of the camera on.

    • Remove the second screw (3.5mm) on the back of the camera to remove the second housing.

    • Once the screws are removed use an opening tool to pry back the second plastic mount.

    Aggiungi Commento

    • Remove 4 (6mm) large screws with a J00 screwdriver.

    • There are 2 on each side. This will allow you to remove the clear housing from the white housing.

    Aggiungi Commento

    • Once screws are removed, pull apart the clear housing.

    • Remove rod from camera cover.

    Aggiungi Commento

    • Remove Large ribbon cable first to disconnect front of camera from main body.

    • Remove 4 (3.5mm) small black screws from motherboard of the camera unit.

    • Remove smaller ribbon cable from underneath yellow tape.

    Aggiungi Commento

    • Once all ribbon cables are removed, remove the motherboard and camera assembly by pulling up on the black camera motherboard.

    Aggiungi Commento

    • Remove 3 (.150") screws from the sync board using the JIS00 screwdriver.

    Aggiungi Commento

    • Use the plastic opening tool to slowly pry the board away from the front housing.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Daniel Bailey

Membro da: 21/03/2018

85 Reputazione

1 Guida realizzata

Team

IUPUI, Team S2-G1, Freund Spring 2018 Membro di IUPUI, Team S2-G1, Freund Spring 2018

IUPUI-FREUND-S18S2G1

2 Membri

2 Guide realizzate

Great tutorial, thanks a lot.

I have a problem with infrared, Netgear isn’t able to help me without seeing the camera.

I would like to ask you….

In the night the red leds light on but you see all black, there is no light entering in the lens system. I think there is a problem in the diaphragm… what do you think?

The first months it works correctly (except once when I see all pink, I fix it restarted the camera).

Thank you!

Matteo

matteor84@hotmail.it

Matteo Runfola - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 40

Tutti i Tempi: 208