Salta al contenuto principale

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

Nerf N-Strike Elite Retaliator Trigger Spring Replacement

Cosa ti serve

  1. Nerf N-Strike Elite Retaliator Trigger Spring Replacement, Case Disassembly: passo 1, immagine 1 di 1
    • While holding the blaster, rotate the barrel assembly in the counter-clockwise direction and pull away from the blaster.

  2. Nerf N-Strike Elite Retaliator Trigger Spring Replacement: passo 2, immagine 1 di 1
    • Remove the stock of the blaster by pushing the orange tabs downward while pulling the stock away from the blaster.

  3. Nerf N-Strike Elite Retaliator Trigger Spring Replacement: passo 3, immagine 1 di 1
    • Remove the magazine from the blaster by forcing the sliding mechanism backwards, pushing the orange tabs downward, and pulling the magazine away.

  4. Nerf N-Strike Elite Retaliator Trigger Spring Replacement: passo 4, immagine 1 di 2 Nerf N-Strike Elite Retaliator Trigger Spring Replacement: passo 4, immagine 2 di 2
    • Remove the stock attachment point by removing the two 8mm Phillips head screws.

  5. Nerf N-Strike Elite Retaliator Trigger Spring Replacement: passo 5, immagine 1 di 2 Nerf N-Strike Elite Retaliator Trigger Spring Replacement: passo 5, immagine 2 di 2
    • Remove the eleven 8mm and two 10mm Phillips head screws from the left side of the blaster, and carefully remove the outer casing.

    • Two of the screws must be removed with the sliding mechanism in the forward position. Another two must be removed with the sliding mechanism in the back position.

    • There are several springs that may become displaced during this procedure. Proceed with the utmost caution.

  6. Nerf N-Strike Elite Retaliator Trigger Spring Replacement, Trigger Spring: passo 6, immagine 1 di 3 Nerf N-Strike Elite Retaliator Trigger Spring Replacement, Trigger Spring: passo 6, immagine 2 di 3 Nerf N-Strike Elite Retaliator Trigger Spring Replacement, Trigger Spring: passo 6, immagine 3 di 3
    • Carefully pull the orange trigger upward and backward to remove it from the blaster.

    • This component is under spring pressure. Wear appropriate personal protective equipment to shield your eyes.

    • Remove the spring from the rear of the trigger.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

ericharman

Membro da: 03/02/16

1.410 Reputazione

5 Guide realizzate

Un commento

ok, taken the spring out. now what?

Kelvin Mead - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 5

Ultimi 30 Giorni: 9

Tutti i Tempi: 9,306