Salta al contenuto principale

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

Nerf N-Strike Elite Retaliator Case Disassembly

Cosa ti serve

  1. Nerf N-Strike Elite Retaliator Case Disassembly, Case Disassembly: passo 1, immagine 1 di 1
    • While holding the blaster, rotate the barrel assembly in the counter-clockwise direction and pull away from the blaster.

  2. Nerf N-Strike Elite Retaliator Case Disassembly: passo 2, immagine 1 di 1
    • Remove the stock of the blaster by pushing the orange tabs downward while pulling the stock away from the blaster.

  3. Nerf N-Strike Elite Retaliator Case Disassembly: passo 3, immagine 1 di 1
    • Remove the magazine from the blaster by forcing the sliding mechanism backwards, pushing the orange tabs downward, and pulling the magazine away.

  4. Nerf N-Strike Elite Retaliator Case Disassembly: passo 4, immagine 1 di 2 Nerf N-Strike Elite Retaliator Case Disassembly: passo 4, immagine 2 di 2
    • Remove the stock attachment point by removing the two 8mm Phillips head screws.

  5. Nerf N-Strike Elite Retaliator Case Disassembly: passo 5, immagine 1 di 2 Nerf N-Strike Elite Retaliator Case Disassembly: passo 5, immagine 2 di 2
    • Remove the eleven 8mm and two 10mm Phillips head screws from the left side of the blaster, and carefully remove the outer casing.

    • Two of the screws must be removed with the sliding mechanism in the forward position. Another two must be removed with the sliding mechanism in the back position.

    • There are several springs that may become displaced during this procedure. Proceed with the utmost caution.

Linea Traguardo

Altre 28 persone hanno completato questa guida.

ericharman

Membro da: 03/02/16

1.410 Reputazione

5 Guide realizzate

14 Commenti

How do I clean the slider track?

devinwhaley - Replica

you probably should not do that. i think its oily for a reason.

one smol birb -

You shouldn't. That oily substance is lubricant, which is crucial for smooth functionality.

SirMikay -

Mine had a chopped off dart head stuck in the trigger mechanism.

I had to partially disassemble in order to be able to free the slide which was covering 1 screw.

Overall, it was very easy. Only challenge is keeping track of the screws, as they're not all the same.

Pete Isaacs - Replica

Boo this sucks

Mark Green - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 7

Ultimi 7 Giorni: 31

Ultimi 30 Giorni: 148

Tutti i Tempi: 34,632