Neato Botvac D8000 Top Face Panel Replacement

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

Introduzione

These step-by-step instructions are provided so you can remove the top cover of the robot. This can be done as a step to remove the wheel or check the wiring.

Cosa ti serve

Passo 1 Top Face Panel

Neato Botvac D8000 Top Face Panel Replacement, Top Face Panel: passo 1, immagine 1 di 1

Grab the rear bumper with both hands on either side.

Traduci

Passo 2

Firmly pull the bumper forward at a steady pace.
When pulling the bumper forward avoid being too rough because the bumper might break.

Traduci

Passo 3

Looking from above, remove the two 11mm screws with a Torx T10 screwdriver.

Traduci

Passo 4

Neato Botvac D8000 Top Face Panel Replacement: passo 4, immagine 3 di 3

Place the robot on its back and remove the six 11mm screws using a Torx T10 screwdriver.

Traduci

Passo 5

Neato Botvac D8000 Top Face Panel Replacement: passo 5, immagine 3 di 3

Push the clips, located in the back side, inward.
Gently lift up the top cover until you can see the wires. Then gently un-clip all the wires.
When you lift the top cover be careful because the wires are thin and fragile.