Salta al contenuto principale

Neato Botvac D8000 Top Face Panel Replacement

Cosa ti serve

  1. Neato Botvac D8000 Top Face Panel Replacement, Top Face Panel: passo 1, immagine 1 di 1
    • Grab the rear bumper with both hands on either side.

  2. Neato Botvac D8000 Top Face Panel Replacement: passo 2, immagine 1 di 2 Neato Botvac D8000 Top Face Panel Replacement: passo 2, immagine 2 di 2
    • Firmly pull the bumper forward at a steady pace.

    • When pulling the bumper forward avoid being too rough because the bumper might break.

  3. Neato Botvac D8000 Top Face Panel Replacement: passo 3, immagine 1 di 2 Neato Botvac D8000 Top Face Panel Replacement: passo 3, immagine 2 di 2
    • Looking from above, remove the two 11mm screws with a Torx T10 screwdriver.

  4. Neato Botvac D8000 Top Face Panel Replacement: passo 4, immagine 1 di 3 Neato Botvac D8000 Top Face Panel Replacement: passo 4, immagine 2 di 3 Neato Botvac D8000 Top Face Panel Replacement: passo 4, immagine 3 di 3
    • Place the robot on its back and remove the six 11mm screws using a Torx T10 screwdriver.

  5. Neato Botvac D8000 Top Face Panel Replacement: passo 5, immagine 1 di 3 Neato Botvac D8000 Top Face Panel Replacement: passo 5, immagine 2 di 3 Neato Botvac D8000 Top Face Panel Replacement: passo 5, immagine 3 di 3
    • Push the clips, located in the back side, inward.

    • Gently lift up the top cover until you can see the wires. Then gently un-clip all the wires.

    • When you lift the top cover be careful because the wires are thin and fragile.

  6. Neato Botvac D8000 Top Face Panel Replacement: passo 6, immagine 1 di 1
    • Once you have carefully removed the wire clip; you can fully remove the top cover.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 2 persone hanno completato questa guida.

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 4

Tutti i Tempi: 910