Salta al contenuto principale

Introduzione

Follow these steps to remove or replace a dead battery from your Neato Botvac D8000.

Parti

Nessuna parte specificata.

  1. Turn the robot upside down to locate the battery cover. Turn the robot upside down to locate the battery cover.
    • Turn the robot upside down to locate the battery cover.

  2. Batterie per PC portatili

    Una soluzione semplice per un grande aumento di potenza.

    Acquista ora

    Batterie per PC portatili

    Una soluzione semplice per un grande aumento di potenza.

    Acquista ora
  3. Use a Phillips #1 screwdriver to unscrew both of the 20mm screws. Gently lift the battery cover. Remove the battery cover to reveal the battery.
    • Use a Phillips #1 screwdriver to unscrew both of the 20mm screws.

    • Gently lift the battery cover.

    • Remove the battery cover to reveal the battery.

  4. Use a flathead screwdriver to push down on the latch of the battery clip. Simultaneously, pull on the battery while pushing down on the latch to detach the battery from the clip. Do not pull on the wires that are connected to the battery.
    • Use a flathead screwdriver to push down on the latch of the battery clip.

    • Simultaneously, pull on the battery while pushing down on the latch to detach the battery from the clip.

    • Do not pull on the wires that are connected to the battery.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Michelle Sanchez

Membro da: 22/03/2018

147 Reputazione

1 Guida realizzata

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 5

Tutti i Tempi: 250