NETGEAR WGT624 v3 Antenna Replacement

Jonathon Sather e 5 altri collaboratori

Ultimo aggiornamento il May 7, 2024

15 minuti

Moderato

Guida Studente in Evidenza

Introduzione

Vai al passo 1

Removing the antenna will allow you access to other parts of the device or it can replace the antenna if it is not working properly.

Cosa ti serve

Ricambi

NETGEAR WGT624 v3 antenna

Strumenti

Mostra di più…

Passo 1 Lower Case

NETGEAR WGT624 v3 Antenna Replacement, Lower Case: passo 1, immagine 1 di 1

Turn the device so that the bottom is facing up.

Traduci

Passo 2

NETGEAR WGT624 v3 Antenna Replacement: passo 2, immagine 3 di 3

Use the plastic opening tool to carefully lift the rubber stops in each corner.
Do not completely remove the rubber stops, because they are difficult to replace.

Traduci

Passo 3

Unscrew the 4 11.8 mm T-8 Torx screws from each corner of the device.

Traduci

Passo 4

Lift the lower case straight up from the rest of the router.

Traduci

Passo 5 Motherboard

NETGEAR WGT624 v3 Antenna Replacement, Motherboard: passo 5, immagine 1 di 2

NETGEAR WGT624 v3 Antenna Replacement, Motherboard: passo 5, immagine 2 di 2

Remove the clear plastic casing by lifting it straight up from the router.

Traduci

Passo 6

Separate the motherboard from the top shell by lifting it straight up from the router.

Traduci

Passo 7 Antenna

NETGEAR WGT624 v3 Antenna Replacement, Antenna: passo 7, immagine 1 di 1

Turn the motherboard, so that the top is facing upwards.
Place the motherboard on a clean flat surface.

Traduci

Passo 8

Remove the yellow tape that holds the wire.
Make sure that you set the tape aside on a clean surface, so that it can be reused.

Traduci

Passo 9

NETGEAR WGT624 v3 Antenna Replacement: passo 9, immagine 3 di 3

Attrezzo utilizzato in questo passaggio:

Tweezers

$4.99

Aggiungi al carrello

Use tweezers to gently pull the metal bracket that connects the antenna to the motherboard.
The wire should now be completely separate from the motherboard.

Traduci

Passo 10

Extend the antenna away from the device, so that it becomes straight.

Traduci

Passo 11

NETGEAR WGT624 v3 Antenna Replacement: passo 11, immagine 3 di 3

Find the clips that hold the antenna onto the router.
Use one hand to push the clips in, while using your other hand to pull out the antenna. You may need to gently twist the antenna so it can separate from the hole.
The antenna may take considerable force to remove.