Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Store

Introduzione

The sound buttons are located on the face of your cube underneath the colored instrument pictures.

  1. Remove two 6 mm Phillips #2 screws  on either side of the On/Off Plate. Remove two 6 mm Phillips #2 screws  on either side of the On/Off Plate.
    • Remove two 6 mm Phillips #2 screws on either side of the On/Off Plate.

  2. Remove the On/Off switch plate and save the screws so you can use them later to put the plate back on.
    • Remove the On/Off switch plate and save the screws so you can use them later to put the plate back on.

  3. Gently pull out the battery cartridge and if needed, replace the batteries with 3 AA alkaline batteries.
    • Gently pull out the battery cartridge and if needed, replace the batteries with 3 AA alkaline batteries.

  4. Starting with the yellow face, insert the metal spudger between the yellow face and the white frame, prying the frame apart.
    • Starting with the yellow face, insert the metal spudger between the yellow face and the white frame, prying the frame apart.

  5. The Essential Toolkit

    The most helpful tools in our most compact kit.

    Acquista ora

    The Essential Toolkit

    The most helpful tools in our most compact kit.

    Acquista ora
  6. Insert the metal spudger in the space created by the plastic opening tool between the frame and face of the cube.
    • Insert the metal spudger in the space created by the plastic opening tool between the frame and face of the cube.

    • Pry the cube face from the frame.

  7. After removing the square plates, you can unscrew the screws underneath.
    • After removing the square plates, you can unscrew the screws underneath.

    • Remove four 6 mm Phillips #2 screws, located on the sides.

  8. Remove the rubber corners by simply pulling them off.
    • Remove the rubber corners by simply pulling them off.

  9. Flip the frame over so that green motherboard over so that the LED is face down and the brown side of the motherboard is face up using the Jimmy to remove the glue connecting the motherboard to the white frame.
    • Flip the frame over so that green motherboard over so that the LED is face down and the brown side of the motherboard is face up using the Jimmy to remove the glue connecting the motherboard to the white frame.

  10. Slide the motherboard out of the frame.
    • Slide the motherboard out of the frame.

  11. To remove the button use your fingers or forceps to remove the gray rubber button piece on the green side of the motherboard. To remove the button use your fingers or forceps to remove the gray rubber button piece on the green side of the motherboard.
    • To remove the button use your fingers or forceps to remove the gray rubber button piece on the green side of the motherboard.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Team

USF Tampa, Team 1-4, Sullivan Fall 2015 Membro di USF Tampa, Team 1-4, Sullivan Fall 2015

USFT-SULLIVAN-F15S1G4

4 Membri

7 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 3

Tutti i Tempi: 421