Introduzione

This guide shows how to replace the logic board.

  1. Remove battery cover by pushing down release lever at top of phone while prying off cover.
    • Remove battery cover by pushing down release lever at top of phone while prying off cover.

    • Set cover aside.

    Aggiungi Commento

  2. Remove battery by grabbing it near the bottom and lifting out.
    • Remove battery by grabbing it near the bottom and lifting out.

    Aggiungi Commento

    • Unscrew four corner screws with T6 screwdriver.

      • Note: The two top screws are short and silver. The two bottom screws are black and long.

    Aggiungi Commento

    • Use a spudger to gently pry off back chassis. Wedge the spudger in crevice between back panel and phone and lift.

    Aggiungi Commento

    • Starting from left side of phone, remove side buttons and place aside.

      • Note: There should be three buttons. One on each side, and the top.

    • Return phone to starting orientation when done.

    Aggiungi Commento

    • Gently remove orange ribbon cable by prying up with spudger.

    Aggiungi Commento

    • Use a spudger to pry up logic board by wedging in between logic board and chassis and lifting.

      • Note: Orange ribbon cable is fragile and can be broken.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Eric Freeman

Membro da: 26/01/2010

1 Reputazione

7 Guide realizzate

Team

Cal Poly, Team 8-48, Regan Winter 2010 Membro di Cal Poly, Team 8-48, Regan Winter 2010

CPSU-REGAN-W10S8G48

4 Membri

13 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 1,754