Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
Attrezzo utilizzato in questo passaggio:Spudger$3.99-
On the phone's face, remove the four rubber caps from the screw covers using a spudger.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Unscrew the four cover screws using a T6 Torx screwdriver, turning counterclockwise.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Loosen and remove the protective cover using a plastic opening tool.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Gently loosen the second protective cover with the plastic opening tool.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Carefully remove the protective cover from the circuitry.
-
Slowly peel the black rubber gasket off of the circuit board.
-
Carefully move the camera out of the way using your hand.
-
Use a flat tool to disconnect the upper and lower circuit boards.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Gently slip the copper strip out from under the circuitry by using your hand.
-
Annulla: non ho completato questa guida.
Altre 2 persone hanno completato questa guida.