Introduzione

If your Moto Z2 Speaker is not not working correctly, use this guide to replace it.

Place the phone on a flat surface with the screen facing up.
  • Place the phone on a flat surface with the screen facing up.

  • Insert the flat end of a nylon spudger into the crease separating the screen and the body in the lower right corner of the phone.

  • Pry open part of the screen by pulling the tool and the screen toward you.

  • You may be required to use a heating element, such as the iOpener, to heat and loosen the adhesive underneath before attempting to pry it open.

Aggiungi Commento

Wedge the plastic opening tool between the gap created by separating the screen and body of the phone in the right hand corner to hold it open.
  • Wedge the plastic opening tool between the gap created by separating the screen and body of the phone in the right hand corner to hold it open.

  • Insert the nylon spudger into the lower left corner of the screen and pry the screen toward you.

  • Continue to insert the plastic opening and spudger tools around the phone, and pry open the screen until it is fully separated from the device.

  • Remove the screen gently and slowly as the screen may crack otherwise.

Aggiungi Commento

  • Remove the screen by pulling from right to left and placing the screen face down on the flat surface next to the main body of the device.

Aggiungi Commento

  • Using the flat end of the nylon spudger, pull off the black tape on top of the screen connector piece that the black ribbon is attached to.

Aggiungi Commento

  • Insert the black spudger under the lock of the latch connecting the black ribbon of the screen to the phone body.

  • Pull up on the lock to unlock the latch.

  • Separate the black ribbon from the latch by pulling gently to the left.

Aggiungi Commento

  • Unscrew the two 3mm T4 screws from the speaker.

Aggiungi Commento

  • Use the nylon spudger to lift and remove the speaker from the phone chassis.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 2 persone hanno completato questa guida.

Team

Cal Poly, Team S2-G1, Livingston Winter 2018 Membro di Cal Poly, Team S2-G1, Livingston Winter 2018

CPSU-LIVINGSTON-W18S2G1

4 Membri

6 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 16

Ultimi 30 Giorni: 106

Tutti i Tempi: 551