Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the Push Pin to remove the rubber screw covers by pushing the needle into the rubber and pulling up.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the T6 screwdriver to remove the four screws holding the casing together.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Once you get the plastic opening tool in, slide it across the side of the phone, making sure to keep the plastic opening tool wedged in between the two casings.
-
Repeat the 3 steps above for the top, bottom, and opposite side.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the plastic inner cover by placing the spudger under the left-most side and pry to the left and upwards.
-
Gently rotate/wiggle the cover until you can pull it off the phone.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using your fingers, remove the plastic piece that holds the camera in place.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Carefully pry up the upper circuit board with the spudger.
-
The second picture shows what your phone should look like when the upper circuit board is removed.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Take out the camera and attached chip with the iPod removal tool. Carefully pry the chip off its connection and the camera will come out too.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the infra red plastic covering,the button on the left side of the phone, and the earphone cover lid by pulling straight up on them with your fingers.
-
Wedge the plastic opening tool in between the logic board and the small orange band and gently pry upwards.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Wedge the spudger in between the logic board and the front casing and gently lift while pulling away from the orange ribbon.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Wedge the plastic opening tool between the LCD screen and the metal casing holding it in and lift gently.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Simply lift the keyboard buttons with your hands pulling from one side to the other.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the navigation buttons by pushing them with your finger(s) until they come loose.
-
Now simply peel the buttons off.
-
Annulla: non ho completato questa guida.
Un'altra persona ha completato questa guida.