Salta al contenuto principale

Motorola Moto Q Back Casing Replacement

Cosa ti serve

  1. Motorola Moto Q Back Casing Replacement, Back Casing: passo 1, immagine 1 di 1
    • Use the Push Pin to remove the rubber screw covers by pushing the needle into the rubber and pulling up.

    • Be careful not to poke yourself when handling the push pin because it is very sharp.

  2. Motorola Moto Q Back Casing Replacement: passo 2, immagine 1 di 1
    • Use the T6 screwdriver to remove the four screws holding the casing together.

    • Note: they are in the same place where you removed the four rubber coverings

  3. Motorola Moto Q Back Casing Replacement: passo 3, immagine 1 di 2 Motorola Moto Q Back Casing Replacement: passo 3, immagine 2 di 2
    • Wedge the plastic opening tool in between the top and bottom cases. This may require a little or a lot of force so be careful.

    • Note: the phone should be face up and the plastic opening tool should be face downwards

    • Once you get the plastic opening tool in, slide it across the side of the phone, making sure to keep the plastic opening tool wedged in between the two casings.

    • Repeat the 3 steps above for the top, bottom, and opposite side.

  4. Motorola Moto Q Back Casing Replacement: passo 4, immagine 1 di 2 Motorola Moto Q Back Casing Replacement: passo 4, immagine 2 di 2
    • Gently lift and remove the back casing.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Team

Cal Poly, Team 16-33, Maness Winter 2010 Membro di Cal Poly, Team 16-33, Maness Winter 2010

CPSU-MANESS-W10S16G33

4 Membri

10 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 1

Tutti i Tempi: 5,143