Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.
Introduzione
With a few simple steps, this guide shows you how to open your Moto G to get to the innards of your phone.
Cosa ti serve
-
-
You can remove the outer cover on the back of the phone by using a plastic opening tool. After removal the inner back cover will be exposed as shown.
-
This part is moderately difficult, especially if you've never taken the outer back cover off before this point.
-
It may take you several tries, but please be patient. The cover is surprisingly flexible, but not enough to withstand a lot of pressure.
-
-
-
-
Using a T5 Torx screwdriver head, take out the 14 screws (3.5 mm diameter and 5 mm long) that hold the back plate in place.
-
Make sure to keep all of the screws together, as they are very easily lost.
-
The magnetic project mat or a container is a great way to keep all the little metal screws as well as other small metal pieces from being lost.
-
-
-
Use the plastic opening tool to take out the inner back cover after all the screws have been removed.
-
This will expose the motherboard and the attached battery.
-
Take note that once the inner back cover is removed the volume and power buttons on the side can easily fall out or be removed.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Annulla: non ho completato questa guida.
Altre 9 persone hanno completato questa guida.