Introduzione

Replace the main logic board for your Motorola MOTO phone.

Parti

Nessuna parte richiesta.

  1. Using your finger, press down on the clip holding the back cover on Pull the back cover off.
    • Using your finger, press down on the clip holding the back cover on

    • Pull the back cover off.

  2. Place thumb and index finger in the spaces on either side of the battery. Pull battery out.
    • Place thumb and index finger in the spaces on either side of the battery.

    • Pull battery out.

  3. Using the T5 Torx-screwdriver, remove the four 5.5 mm screws on the back panel.
    • Using the T5 Torx-screwdriver, remove the four 5.5 mm screws on the back panel.

  4. Spedizione gratuita per tutti gli ordini superiori a 100 US$ o contenenti un Kit Attrezzi Pro Tech!

    Sfoglia il Nostro Negozio
  5. Using a plastic opening tool, carefully peel back the rubber strip located at the bottom of the keypad Remove the two T5 Torx-screws underneath the rubber strip using the T5 Torx-screwdriver
    • Using a plastic opening tool, carefully peel back the rubber strip located at the bottom of the keypad

    • Remove the two T5 Torx-screws underneath the rubber strip using the T5 Torx-screwdriver

  6. Using the flat end of the plastic opening tool, insert it in the gap between the charging port and plastic at the bottom left side of the phone. Slide the opening tool around the phone clockwise until you reach the audio port. Twist the opening tool until the plastic pops off from the body of the phone. This make require a small amount of force.
    • Using the flat end of the plastic opening tool, insert it in the gap between the charging port and plastic at the bottom left side of the phone.

    • Slide the opening tool around the phone clockwise until you reach the audio port.

    • Twist the opening tool until the plastic pops off from the body of the phone. This make require a small amount of force.

  7. Remove the plastic covering completely from the body of the phone.
    • Remove the plastic covering completely from the body of the phone.

  8. Using the plastic opening tool, carefully unclip the cable ribbon from the main logic board. Be sure not to tear it because the flex is very fragile. Remove the main logic board.
    • Using the plastic opening tool, carefully unclip the cable ribbon from the main logic board. Be sure not to tear it because the flex is very fragile.

    • Remove the main logic board.

Conclusione

To reassemble your device, follow these instructions in reverse order.

C Miller

Membro da: 25/06/2012

38 Reputazione

3 Guide realizzate

Team

Cal Poly, Team 1-3, Regan SU 2012 Membro di Cal Poly, Team 1-3, Regan SU 2012

CPSU-REGAN-SU12S1G3

2 Membri

14 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 1

Tutti i Tempi: 1,319