Aggiusta la tua roba Comunità Store

Motorola MBP33SBU Baby Unit Speaker Replacement

Introduzione

The Baby Unit Speaker allows sound between the two units. You will need a soldering kit to successfully install a new speaker.

Cosa ti serve

  1. Motorola MBP33SBU Baby Unit Speaker Replacement, Baby Unit Speaker: passo 1, immagine 1 di 3 Motorola MBP33SBU Baby Unit Speaker Replacement, Baby Unit Speaker: passo 1, immagine 2 di 3 Motorola MBP33SBU Baby Unit Speaker Replacement, Baby Unit Speaker: passo 1, immagine 3 di 3

    • Using precision tweezers, remove the (4) four rubber feet from the bottom of the baby unit.

    • Using a Phillips #1 screwdriver remove the 9.5mm screws that were under the rubber feet.

    • Open the base of the baby unit.

    Modifica

  3. Motorola MBP33SBU Baby Unit Speaker Replacement: passo 2, immagine 1 di 3 Motorola MBP33SBU Baby Unit Speaker Replacement: passo 2, immagine 2 di 3 Motorola MBP33SBU Baby Unit Speaker Replacement: passo 2, immagine 3 di 3

    • Using the Phillips #1 screwdriver remove the 9.5mm washer head screws holding the speaker in place.

    • Gently lift the speaker by the wires from its plastic base.

    Modifica

  4. Motorola MBP33SBU Baby Unit Speaker Replacement: passo 3, immagine 1 di 2 Motorola MBP33SBU Baby Unit Speaker Replacement: passo 3, immagine 2 di 2

    • Desolder the wires connecting the speaker to the circuit board.

    • Beware of overheating, the soldering kit is capable of damaging the circuit board.

    • Beware of the potential for personal injury from heated metals.

    • For soldering procedures please refer to iFixit's guide to Soldering Skills.

    Modifica
Conclusione

To reassemble your device, follow these instructions in reverse order.

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 2

Ultimi 7 Giorni: 7

Ultimi 30 Giorni: 13

Tutti i Tempi: 1,930