Introduzione

Use this guide to replace the pull-out antenna through the back of the device.

Parti

Nessuna parte richiesta.

Remove the battery by sliding it down the rails to which it is connected.
  • Remove the battery by sliding it down the rails to which it is connected.

Aggiungi Commento

Locate a Flat-head or a Phillips head screwdriver.
  • Locate a Flat-head or a Phillips head screwdriver.

  • Insert the screwdriver into the holes that connect the key pad guard to the rear casing in the plastic rod.

  • The following step may require a substantial amount of force.

  • Use the screwdriver to push the rods towards each other until they click out of their locked positions.

Aggiungi Commento

  • Slide off the antenna guard and locate the four clips on the exterior of the rear casing.

  • Simultaneously push the clips outward while lifting the rear casing and keyguard away from the front casing.

Aggiungi Commento

  • Locate and unplug the black component of the current antenna from the motherboard.

  • Under the black component should be a blue component. Unscrew this component in order to free the antenna.

Aggiungi Commento

  • Slide the antenna out of the green tubing.

  • Slide the green tubing out of its hole.

Aggiungi Commento

  • Insert the new green tubing into the corresponding slot.

Aggiungi Commento

  • Insert the new antenna into the green tubing.

Aggiungi Commento

  • Screw the blue piece of the antenna into the threaded hole on the motherboard until it is tight.

Aggiungi Commento

  • Align the protruding wire on the black component with the corresponding hole on the motherboard.

  • Push the wire into the hole.

Aggiungi Commento

  • Reverse the instructions from Step 2 to re-install the keypad guard and rear casing onto the device.

Aggiungi Commento

  • Push down on the antenna guard until it clicks into place.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Andrew Lam

Membro da: 17/04/2012

28 Reputazione

5 Guide realizzate

Team

Cal Poly, Team 9-46, Regan Spring 2012 Membro di Cal Poly, Team 9-46, Regan Spring 2012

CPSU-REGAN-S12S9G46

5 Membri

8 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 4

Tutti i Tempi: 1,446