Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Insert the plastic opening tool into the middle of the bottom edge of the device. The tool should be inserted within the seam between the back and front covers.
-
Slide the opening tool to the right and slowly continue to separate the back cover from the device.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Pull the cover off of the device once about three quarters of the cover has been pried open using the plastic opening tool.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Pry the battery from the base using the nylon spudger and move it away from the motherboard.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
De-solder the three contact points and remove the battery.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the two ZIF connectors attached to the motherboard by flipping up the black tabs before pulling the ribbon cable away.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the nut driver and J00 bit to remove the three 4 mm screws.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Peel back metal tape that is hiding the auxiliary port wires.
-
Remove tape that is holding the speaker wires in place.
-
Lift up on the motherboard to release it from the tablet.
-
Annulla: non ho completato questa guida.
Un'altra persona ha completato questa guida.