Salta al contenuto principale

Introduzione

How to remove the cutting head's blade cover for replacement or further device service for the Mk Diamond Wet Saw MK660 2010.

Strumenti

Nessun attrezzo specificato.

  1. Before you begin, make sure to power off and unplug the device from the outlet. If the clear water pump hose is connected, remove it now. Loosen the plastic knob holding the saw's cutting head in place.
    • Before you begin, make sure to power off and unplug the device from the outlet.

    • If the clear water pump hose is connected, remove it now.

    • Loosen the plastic knob holding the saw's cutting head in place.

    • Lower the cutting head while keeping it steady.

  2. Unscrew the knob. Remove it from the cutting head.
    • Unscrew the knob.

    • Remove it from the cutting head.

  3. Loosen the plastic knob holding the blade cover in place. Loosen the plastic knob holding the blade cover in place.
    • Loosen the plastic knob holding the blade cover in place.

  4. Loosen the wing nut on the blade cover pivot shaft. Remove the wing nut and accompanying washer. Remove the wing nut and accompanying washer.
    • Loosen the wing nut on the blade cover pivot shaft.

    • Remove the wing nut and accompanying washer.

  5. Pivot the blade cover up and pull it off the shaft. Pivot the blade cover up and pull it off the shaft.
    • Pivot the blade cover up and pull it off the shaft.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Carsten Frauenheim

Membro da: 10/03/2020

55.274 Reputazione

293 Guide realizzate

Team

iFixit Membro di iFixit

Community

138 Membri

17.019 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 2

Tutti i Tempi: 25