Salta al contenuto principale

Minolta QTsi Maxxum View Finder Replacement

Cosa ti serve

  1. Minolta QTsi Maxxum View Finder Replacement, View Finder: passo 1, immagine 1 di 1
    • Locate the battery compartment on the bottom panel of camera.

    • Use a small coin to untwist and open the batter compartment door.

    • Twist the coin counterclockwise to unlock the battery compartment door.

  2. Minolta QTsi Maxxum View Finder Replacement: passo 2, immagine 1 di 1
    • Two batteries are located inside the battery compartment

    • Be careful, the batteries inside the compartment are small and easy to lose.

    • Remove the two batteries from inside the battery compartment by individually pulling each out.

  3. Minolta QTsi Maxxum View Finder Replacement: passo 3, immagine 1 di 1
    • When the batteries are removed from the compartment, one screw will be visible in the bottom of the chamber.

    • Unscrew the (1) black Phillips #00 5mm screw from the bottom of the battery chamber.

    • Be careful when unscrewing the screw because it's small and is easy to lose.

  4. Minolta QTsi Maxxum View Finder Replacement: passo 4, immagine 1 di 1
    • Remove the (2) black Phillips #00 5mm screws that lie on either side of the view finder.

    • Be careful because the two screws are small and are easy to lose.

  5. Minolta QTsi Maxxum View Finder Replacement: passo 5, immagine 1 di 1
    • Remove the (1) black Phillips #00 5mm screw from underneath the flash hood.

    • Be careful because the screw is small and is easy to lose.

  6. Minolta QTsi Maxxum View Finder Replacement: passo 6, immagine 1 di 2 Minolta QTsi Maxxum View Finder Replacement: passo 6, immagine 2 di 2
    • Once all screws are removed, the top of the camera should come off easily.

    • Be careful when removing the top, there are wires connected that could be damaged.

  7. Minolta QTsi Maxxum View Finder Replacement: passo 7, immagine 1 di 1
    • The viewfinder will fall when the screws are removed.

    • Remove the (2) black Phillips #00 5mm screws that hold the viewfinder.

    • Be careful because the screws are small and easy to lose.

Conclusione

To reassemble your device, follow these instructions in reverse order.

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 4

Ultimi 30 Giorni: 10

Tutti i Tempi: 792