Salta al contenuto principale

Minolta QTsi Maxxum Shutter Button Replacement

Cosa ti serve

  1. Minolta QTsi Maxxum Shutter Button Replacement, Shutter Button: passo 1, immagine 1 di 1
    • Locate the battery compartment on the bottom panel of the camera.

    • Open the battery door by using a coin.

    • In the counterclockwise direction, twist the coin in the battery door groove to open it.

  2. Minolta QTsi Maxxum Shutter Button Replacement: passo 2, immagine 1 di 1
    • Two batteries are located inside the battery chamber.

    • Remove the two batteries from the battery chamber by picking them up.

  3. Minolta QTsi Maxxum Shutter Button Replacement: passo 3, immagine 1 di 1
    • There is a screw located underneath the batteries in the battery compartment.

    • Unscrew and remove the (1) black Phillips #00 5mm screw from the battery compartment.

    • Ensure good lighting before attempting to remove this screw because it is hard to see inside the compartment.

  4. Minolta QTsi Maxxum Shutter Button Replacement: passo 4, immagine 1 di 1
    • From underneath the flash assembly, remove the (1) black Phillips #00 5mm screw

    • Be careful because you can lose the screw

  5. Minolta QTsi Maxxum Shutter Button Replacement: passo 5, immagine 1 di 1
    • The only screws remaining that hold the top panel of the camera in place are located next to the view finder.

    • Remove the (2) black Phillips #00 5mm screws from both sides of the view finder.

    • Be careful because you can lose the screw

  6. Minolta QTsi Maxxum Shutter Button Replacement: passo 6, immagine 1 di 2 Minolta QTsi Maxxum Shutter Button Replacement: passo 6, immagine 2 di 2
    • The top panel of the camera should now be easy to lift off. If it is not, make sure that all screws and attachments, listed in steps 1-5, have been removed.

    • Once all screws are removed, lift the top panel from the camera.

    • Be careful when removing the top panel because there are wires connected to it.

  7. Minolta QTsi Maxxum Shutter Button Replacement: passo 7, immagine 1 di 1
    • Use a metal spudger to push the button out of its socket so that you can place a new one in its place.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 7

Tutti i Tempi: 475