Introduzione
Looks as though some experience with a soldering tool may be necessary, so make sure to be safe with these steps!
Cosa ti serve
-
-
First, apply pressure with your thumb on the top of the battery cover.
-
Next, pull down on the cover until it begins to slide.
-
-
-
Unscrew the six 8.0 millimeter long, #0 screws on the backside of the case using the Phillips #0 screwdriver.
-
-
-
-
Remove the circuit board from the front part of the radio case.
-
Clip the red and black connecting wires at the base closest to the circuit bored in the spots denoted by the two red circles.
-
-
-
Solder the new wires to the circuit board in the spots denoted by the two red circles.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Annulla: non ho completato questa guida.
Altre 2 persone hanno completato questa guida.