Introduzione
It will be necessary to solder the wire connection in order to properly complete this installation.
Cosa ti serve
-
-
Remove the old or broken circuit board from the front case by carefully separating it from the back.
-
Clip the red and black wires at the base of the motherboard to completely separate it from the radio case. You should have 2 separate pieces.
-
-
-
-
Reattach the speaker wires and antenna to the new circuit board using a soldering iron. Take caution when using the hot soldering tool!
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Annulla: non ho completato questa guida.
Altre 2 persone hanno completato questa guida.
Team
Cal Poly, Team 19-43, Regan Winter 2013 Membro di Cal Poly, Team 19-43, Regan Winter 2013
CPSU-REGAN-W13S19G43
3 Membri
9 Guide realizzate
