Salta al contenuto principale

Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.

Cosa ti serve

  1. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 1, immagine 1 di 1
    • Use a metal spudger or Zune opening tool to remove the small silver plastic cap on top of the device.

  2. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 2, immagine 1 di 1
    • There are two T3 screws under the cap. Remove both with a T3 screwdriver.

    • Be careful with removing these screws! These screwheads are prone to breaking.

  3. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 3, immagine 1 di 2 : passo 3, immagine 2 di 2
    • Using a metal spudger or Zune opening tool, remove the aluminum backing starting from the top. There are 5 clips on each side and two on the bottom.

    • Be careful not to press the tools in too far; there are exposed cables right inside the edge of the device.

  4. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 4, immagine 1 di 2 : passo 4, immagine 2 di 2
    • Remove the silver tape from the bottom center and the top right. This allows access to the hard drive and the battery.

  5. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    : passo 5, immagine 1 di 3 : passo 5, immagine 2 di 3 : passo 5, immagine 3 di 3
    • Unclick the black bar connecting the orange hard drive cable to the bottom of the hard drive. Gently push towards the bottom of the device on the black bar until you hear a click sound, it is now disengaged from the hard drive.

    • If the cable doesn't come off easily, the black bar has not been un-clicked.

    • The hard drive cable (ZIF cable) is very fragile. Try to keep it in its original shape and bend it as little as possible.

    • Now gently pull the orange hard drive cable to remove it from the hard drive.

    • Lift the hard drive from the device.

    • Hard Drive Replacement Only: Check to make sure the hard drive cable is in good condition and then connect the new hard drive in the same place, following the steps in reverse order.

Linea Traguardo

Altre 8 persone hanno completato questa guida.

turey

Membro da: 11/11/09

400 Reputazione

2 Guide realizzate

Team

Cal Poly, Team 6-5, Maness Fall 2009 Membro di Cal Poly, Team 6-5, Maness Fall 2009

CPSU-MANESS-F09S6G5

5 Membri

5 Guide realizzate

Un commento

what model hard drive did you utilize during its replacement?
thanksss

RAFI V DEMIRJIAN - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 4

Ultimi 7 Giorni: 9

Ultimi 30 Giorni: 43

Tutti i Tempi: 12,523