Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the plastic screw cover located on the bottom of the device. Insert a small flat-headed screwdriver into one side of the cover and gently ease it out. Repeat on the other side.
-
You will need a #00 Phillips screwdriver to remove the two 2.6 mm screws that are exposed.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the blue plastic opening tool to slowly work your way around the edges of the case, releasing the front plate from the bottom case.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Turn the Zune over so the screen faces downward. This will ensure the battery does not fall out and pull on the cable.
-
Pry up from the bottom of the Zune because the headphone jack will not allow you to remove the back case in one pull. You must slide the case up and away from the rest of the Zune.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the small flat head screw driver to gently lift the brown clamp.
-
The clamp will release the battery ribbon cable from the logic board, freeing the battery.
-
Annulla: non ho completato questa guida.
Altre 19 persone hanno completato questa guida.