Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
-
Svita le due viti Torx T5 da 5,08 mm. Le due viti sono posizionate all'estremità destra e sinistra della cerniera del cavalletto.
-
Assicurati di non spanare la testa delle viti mentre le sviti.
-
Dopo aver rimosso tutte le viti fai ondeggiare delicatamente il cavalletto finché la leva nel centro viene liberata, rilasciando il cavalletto.
-
-
-
-
Ora svita le dieci viti Torx T5 da 5,92 mm posizionate sotto il cavalletto.
-
Svita le sette viti Torx T5 da 5,87 mm posizionate sotto il rivestimento della camera. C'è un'etichetta che copre la seconda vite da sinistra.
-
Separa la scocca posteriore dal telaio infilando uno spudger nella fessura tra i due.
-
Continua a far scorrere lo spudger attorno gli angoli e lungo i bordi per liberare i ganci che fissano la scocca al dispositivo.
-
-
-
Ruota il dispositivo di 180° in moco che il bordo inferiore sia rivolto verso di te.
-
Un cavo a nastro collega la batteria fissata sulla scocca posteriore alla scheda madre. Solleva lentamente la scocca finché non riesci ad accedere al cavo.
-
Usa uno spudger per scollegare il cavo dalla sua presa, spingendolo parallelamente alla scheda madre.
-
Rimuovi la scocca posteriore sollevandola dal dispositivo.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Orient the Surface so the side with the charging port is facing you.
-
Use your finger to lift the tab and unplug the orange ribbon from the motherboard.
-
Remove the two 3.6 mm T4 Torx screws that hold the charging port in place.
-
Remove the charging port by sliding it out from the main board.
Any idea where to find one of these charging ports? Do you have a model number for it?
X868156-002 - Micro SD/ Power Adapter Port Assembly
From which site do i purchase it??
-
Annulla: non ho completato questa guida.
Altre 12 persone hanno completato questa guida.
5 Commenti
Can anyone confirm whether this charging port will work for a Microsoft Surface 3 (non-pro)? The port is loose and cannot get a fitting connection with a micro-usb cable. Thank you.
Probably, As They Are The Same Aren’t They? I’d Say About 80% Chance Of It Working, Good Luck!
I’ll Have To Do This Myself Soon, All The Pins Seemed To Have Been Sucked Into The Actual Body Of The Device.
Is the charging circuitry also located on this board or is it only the port?
The light on the charger connector is on when connected to the Surface. Does this suggest that the charger is working or that the Surface is charging? The unit will not turn on. When I turned it on earlier, I got the ‘low battery symbol’ on the screen but after charging I can get nothing on the screen. I am hesitant to take apart.
My surface is not charging anymore, and the pins on the charger are black (at least 2 of them are) does it help to repair the charging port? Or is the charging circuitry located somewhere else?
Thes instructions should include publish date and which generation of Surface they are based on. It’d be unfortunate if lead someone to disassemble a device that has changed.
BigMo - Replica