Aggiusta la tua roba Comunità Store

MerchSource the Black Series Boat Racer Gaskets Replacement

Introduzione

This repair guide will show you how to replace the gaskets in the MerchSource the Black Series Boat Racers toy boat. The gaskets are foam pieces that secure the battery compartment in the boat from water leakage.

Cosa ti serve

  1. MerchSource the Black Series Boat Racer Gaskets Replacement, Gaskets: passo 1, immagine 1 di 2 MerchSource the Black Series Boat Racer Gaskets Replacement, Gaskets: passo 1, immagine 2 di 2

    • Remove the screw on the top of the boat at the rear end using a Phillips #2 screwdriver.

    • Screw length is 16 mm.

    Modifica

  2. MerchSource the Black Series Boat Racer Gaskets Replacement: passo 2, immagine 1 di 3 MerchSource the Black Series Boat Racer Gaskets Replacement: passo 2, immagine 2 di 3 MerchSource the Black Series Boat Racer Gaskets Replacement: passo 2, immagine 3 di 3

    • Remove the top of the boat by sliding it backwards and then pulling it off.

    Modifica

  4. MerchSource the Black Series Boat Racer Gaskets Replacement: passo 3, immagine 1 di 2 MerchSource the Black Series Boat Racer Gaskets Replacement: passo 3, immagine 2 di 2

    • Grab the rubber gasket with tweezers and pull it out of the slot.

    Modifica

  5. MerchSource the Black Series Boat Racer Gaskets Replacement: passo 4, immagine 1 di 3 MerchSource the Black Series Boat Racer Gaskets Replacement: passo 4, immagine 2 di 3 MerchSource the Black Series Boat Racer Gaskets Replacement: passo 4, immagine 3 di 3

    • Gently remove the gasket and replace with a new one.

    Modifica
Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 5

Ultimi 30 Giorni: 6

Tutti i Tempi: 263