Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Unplug the device from the wall and turn the powerbase upside down.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a #2 Phillips Head Screwdriver to unscrew the four 10 mm screws located on the bottom of the power base.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use slight tension to remove the plastic base from the NutriBullet once all of the screws are removed.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Lift the power cord to remove it from the side slot on the curved base.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a #2 Phillips Head Screwdriver to remove the two 10 mm screws that secure the white bracket down.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a #2 Phillips Head Screwdriver to remove the three 10mm screws that keep the base in place.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use slight tension to remove the curved base by lifting it upward off of the outside casing.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Wiggle the outside casing upward until it separates from the powerbase.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Place the NutriBullet powerbase on the table so that the three rubber screw covers are visible along the bottom of the well. Remove the covers using either tweezers or your fingers.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the three 15mm screws with the Philips Head 2 Screwdriver.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Turn the NutriBullet powerbase upside down and remove the plastic casing by lifting it up. You may have to wiggle the casing in order to break away any hardened material.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Determine which activator(s) fail to work by applying pressure to them. Then, remove the two 15mm screws that hold the activators in place by using the Philips Head 2 screwdriver.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using slight tension, pull the loose activator from the slot.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Open up the green switch. The metal tab and black button will fall out. Fiddle around with the metal switch on the inside to snap it back into place and then reassemble carefully. It should make a clicking noise.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Before reassembling, you should clean up any material that has accumulated on the various parts. Be sure to keep water away from the motor, switches and other electrical components.
-
Annulla: non ho completato questa guida.
Altre 56 persone hanno completato questa guida.
44 Commenti
Thank you. I would have went nuts looking for the screw under the rubber pieces. Would have probably destroyed the whole machine.